Recent content by jpearceTX

I recently took my rear door panels off and put everything back together. The other day I noticed that the rear door know things that you can pull up to unlock the car are a different height in the back than they are in the front. I am wondering if I didn't clip the ones in the rear back...

I have had to take my 2022 Ram 1500 Laramie door panels off a couple of times. No matter how careful I am I always end up breaking a panel push pin. Now I have to take the passenger panel off again as it sounds like the plastic push pin is rolling around in the door. Does anyone have any...

I just noticed that the turn signal indicator lights on my side mirrors are not working on my 2022 Ram 1500 Laramie. I am not sure when they stopped working. I recently fished 2 wiring harnesses through the side mirrors for auto dim and blind side monitoring and I am hoping I didn't screw...

Yes I was able to finally figure everything out and was able to test the blind spot monitoring without the mirrors and everything works great. I was able to enable the BSM using my Tazer DT and the options showed up on Uconnect to select how to setup the BSM warning. Now I was wondering if...

Nevermind. I used a small little camera and was able to find the tab that needs to be pressed down and then you can turn the connector off.

Thanks for the picks. How were you able to get the wire harness connector disconnected from the tail light assembly in order to insert the necessary wire pins for the BSM sensor? I havent had any luck finding the so called pin that needs to get pressed from the inside.

Hi, I am hoping someone can help with this as I am stuck. I am adding the BSM sensors to my 2022 Ram Laramie. I got the correct wire harness from @Jimmy07 . I dremeled out the hole for the sensor. I can't for the life of me figure out how to get the existing harness, that's part of the...