Recent content by johncode

Powder coat Chevy orange

Yes. The only thing “different” on any 1500 is if you have air suspension. They fit all but with air you need to take off an extra bracket for air equipment.

I just swapped them. Went through the heights and it figured it out.

Before links in normal(factory wheels) and after(silver wheels)

I use Shifts and Grins links that cost less than half of the Revel links and do the same thing. Mine are set at an inch with no loss of the modes and close to stock ride. It’s not level but I like the stance better since level sometimes makes it look saggy in the back(to me).

Checked my property for storm/flood damage and snagged a few non pavement shots

Finally got mine from powder coat and installed.

I’ll see how the settle at factory psi. I know water isn’t as good as chalk testing but looks like it’s a little over inflated

Yeah I’m going to up the psi tomorrow and see how she goes. Too wet to do a chalk test.

55 front/45 rear. I do like the feel of 40 all around though.

Yes but wouldn’t 20 inch wheels have lower pressure?

Dealer said they were looking into it. Have an oil change due in about a month so may just do it then. Just thought it was odd I couldn’t find anything mentioning the issue.

40 all around. Says fill front to 55 here’s a pic of the sag at contact

For reference just 0 offset 20x9 wheels

I upgraded my factory 18 inch tire and wheels to 20x9 with 285/60r20. After the change my tire pressure reads low in the front and says inflate to the factory 55 psi. Discount tire says it works itself out but it’s been about 100 miles so far and still reads low. I googled and searched and just...