Recent content by jmill012

It’s called aero mode. Short for aerodynamic… so either we both are dumbasses or Ram meant for us to be confused 😂

Similar to yours. Revel told me you can hear a click/pop when they set properly. So as long as you hear that you should be good. Btw. Where did you measure for the 2.5? Revel pre set mine and I measure 2.5 inches red line to red line in the photo attached.

Correct but by adding a space up front with the links you end up with the same amount length in the airbag. I added 1/2 inch total to the air bag length in the front and rear when all was said and done. Not enough to make a difference and the ride quality is identical. In theory I could...

First made them the same length as the factory links. Then made them 6 full turns longer.

That’s what I did. Worked perfectly!

No just one end. Loosen the nut. Adjust. Put it back on then tighten the nut down.

Closed all the way is a lot of lift in the front. Why are you adjusting them that short? Also they aren’t fully seated on the bottom. Most likely because they are way too short.

To raise the front you make the links shorter. They should be 2.5 inches long from opening (where they attach to the arm on the sensor) to opening. Rear I took out the rear link. Made the revel link the same size then INCREASED the size of the revel link by 6 turns. Making the front shorter...

Measured garage floor to center of fender flare/wheel well opening Rear - 41.25 inches Front - 40.75 inches I’m running 285/55/22 at 40psi Your height with 35s?

I am happily with the setup. Looks level. Went with 6 turns above factory on the rear. I’m now have about 1/4 inch rake. Which means it seems 2 turns is 1/4 inch since I did 6 and originally was 1/2 inch nose high. Thoughts? Edit: sorry it’s parked on a slight incline. I can grab a better...

Thanks! I did exactly as you said and will be installing tomorrow. I saw one set of instructions that said 3 turns was 1/4 inches and another that said it was 2 turns for 1/4 an inch. Given I’m 1/2 nose high. I guess 6 turns will work for me either way.

Installed the front and need someone to help me with what length to set the back links at to life the rear 1/2 inch?

I got the front installed today but it was almost dead level without using the rear links. Right now I’m about 1/2 inch nose high. If I install the back links that were preset from revel, how much will that raise the rear of the truck? I rather have a little rake than be nose high but wonder...

They are wide and will rub with the factory offset, may want to consider a 285/55/22 which is just under 35 inches but only 11.2 wide.

Ill have a set with 2500 miles on them for sale in a week or two ;)