Recent content by Cmassey31099

Do I need to use alfa to do this? Sent from my iPhone using Tapatalk

I’ve had this for well over a year now with no issues. Been getting the software updates over WiFi popup when I start up every time and I cannot get rid of it. It doesn’t connect to my WiFi or hotspot and tried turning off updates over WiFi and it still comes up. It throws my phone off Bluetooth...

Hey all, selling the blind spot modules if anyone is interested in adding that feature. Ended up grabbing the already built in taillights from a junkyard. Shoot me a message. Sent from my iPhone using Tapatalk

This worked! Thanks! Took it for a spin and everything is working and codes are gone. Sent from my iPhone using Tapatalk

Tried again and I cleared everything but C10D0. I need to disable EPB In-Plant Mode for this? I just keep getting “Failed. Service Not Supported In Active Diagnostic Session. Sent from my iPhone using Tapatalk

It’s reading my Vin and I’m getting these C220B C2206 U140E C006A C0042 C10D0 I also tried turning the truck on and the ACC button isn’t even bringing up anything. Took a little break from the 100 degree heat so I’m going to go back out and try it all again soon. Sent from my iPhone using...

Yeah I continued to cycle through each step but still getting most of the faults Sent from my iPhone using Tapatalk

I have everything required and just needed the ACC switch and HCU/ABS. I’m using a brand new ABS and a used HCU off a 2019 limited with ACC. I manually bled the brakes and started following the procedures, the ECU initialization worked but the longitudinal sensor calibration keeps failing. I’ve...

Anyone have luck getting an HCU lately? Every site seems to have it on back order Sent from my iPhone using Tapatalk

I am looking too and getting the same thing. Though it doesn’t seem like the HCU or ABS module are in stock anywhere. Sent from my iPhone using Tapatalk

Did you ever get your mileage updated? I also upgraded my cluster to the full digital one and have not found a way yet Sent from my iPhone using Tapatalk

So I've already gone from UC4 8.4 to UC4 12. Reading through this thread it looks like I just need a UC5 screen (68526598AC; I don't have lane keep but would like to add it in the future) and a UC5 module (68504644AF) along with the harness. Am I missing anything else?

Thanks!! Sent from my iPhone using Tapatalk

Thanks for the response, is that something that should instantly turn it off or will it take a few cycles? The light is still on and it says the rears are good but the fronts are at 41-42 but it’s now telling me to inflate to 40.

I have a rebel and went from the stock tires to 35x12.50x18. I was able to adjust the tire size for the speedometer but I am having trouble adjusting the TMPS threshold and have the annoying alert on my dash. Does anyone know in JScan how to fix it? I think it’s currently at 45 front and 55...