Recent content by Americancatfarmer

I installed these with a bilstein 5100 level and a set of rough county upper control arms and no spacers.

I had to reuse my factory strut nuts because I couldn’t thread using the ones included with the 5100’s

That can anger anyone

I’ve read up on the claytons, I think I’ll stick with the 5100s up front but I may switch to new springs in the rear if I don’t like the spacer. Did you have the diamond back cover on before you added the new rear springs? I know that’s a heavy cover

I installed the 5100 struts myself so I’ve did a few coil spring installs. Thank you

Ordered!! Thank you, I’ll report back once I install

Do you have a brand in mind that you’d recommend ?

Okay, I’ll order the 1/2” and see how that looks. Thank you

I don’t remember the before measurements. No air lift, no ram boxes. I have an undercover tri fold bed cover and usually have a loaded 45 yeti in the bed.

Hey all, I have a 20 rebel and 2 weeks ago I added the 5100 struts on level 5 and rough country upper control arms. The truck sits roughly 1/2 and inch high in the front. I really don’t want to take the front end apart to lower the slot to a different slot. I’m willing to replace the spring...

Noticed this scratch on my rear passenger side flare and I think the only option is replacement but I can’t find them online

My 2020 rebel

I’ll buy

Here ya go

I have a 2020 rebel with all black interior but I didn’t like the 12 so I have the 8.4 screen