5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Rubbing with 35” tire on 20x12 wheels with 3.5” RC lift?

Joined
Jan 21, 2019
Messages
11
Reaction score
7
Points
3
Age
29
Anyone have the RC 3.5” Lift and have 20x12 wheels with 33-35” tires? Wondering if you’re having any clearance issues!
 
Anyone have the RC 3.5” Lift and have 20x12 wheels with 33-35” tires? Wondering if you’re having any clearance issues!
If you have a -44 offset you will have clearance issues unless you do some cutting. I have 33 and rubs at full turn.
 
Yes, my 35x12.5 tires on ‘0’ offset 20x9 wheels did rub with 3 1/2” RC lift. I had to trim some plastic on the lower rear of the front fender wells. Details in my thread “All Fixed Up, tires, wheels, exc.” Truck details in my signature.
 
I’m probably only going to do 33’s on my 20x12s so I don’t have to do too much trimming if any
 
Very nice!! I plan on doing something similar (20x12 -44 Fuel wheels wrapped in Cooper AT3's in 325/60/20). Did you have any clearance issues?
Thanks. There is rubbing at full turn with a 2.5in level on it.
 
Oh ok. Was there a lot of trimming you had to do also?
I haven't trimmed anything yet. Didn't want to cut on the truck just yet, but there is a thread on here where someone shows where to cut behind the trim and replace but haven't had time to do it. I just dont turn hard or I make wide turns or go and come back.
 

Users who are viewing this thread

Back
Top