What offset is everyone running?

[Ready Go]

Also, once again..keep in mind I have 6mm/0.25" Bora spacers in back to get the back tire looking flush (or in line) with the front tire.
Also, the front tire alignment does slightly change the poke of the front tire just a fraction based on camber amounts.

 

[1BADRAMLIMITED]

I AM ON 35 X 12.5 X 20 ON A 20X9 0 OFFSET AND HAVE A AGGRESSIVE SIDE LUG TIRE (KENA KLEVER R/T) AND YOU CAN BARELY SEE IT GOES PAST THE OEM FLARES. I MEAN YOU HAVE TO BE OUT THERE W/ A RULER AND TAPE MEASURE TO SEE ITS TRULY OUTSIDE THE FLARES

ALSO HAVE PLENTY OF ROOM BETWEEN UCA AND TIRE

 

[A-TEAM]

Thanks for the info guys! Im leaning towards the 285/60-20, there are many tires available in this size. My concerns with my UCA is they are RC forged aluminum and have much larger ball joints then factory, so they are closer to the tire than the OEM setup. Also are you guys running hub centric bore adaptors? Im thinking I’ll pick some up before mounting. I figure they cant hurt keeping everything lined up an concentric during tightening.

 

[Ready Go]

Thanks for the info guys! Im leaning towards the 285/60-20, there are many tires available in this size. My concerns with my UCA is they are RC forged aluminum and have much larger ball joints then factory, so they are closer to the tire than the OEM setup. Also are you guys running hub centric bore adaptors? Im thinking I’ll pick some up before mounting. I figure they cant hurt keeping everything lined up an concentric during tightening.

Your new XDs should have bore/hub centric adapters with them..usually 1 or 2 sizes.
If not, Amazon has them...Billet or Plastic/Nylon ones.