Adding power adjustable pedals

[1500V]

I would like to add power adjusting brake and gas pedals to my 2023 Ram 1500 Tradesman. It seems easy and cheap enough to get the pedal assembly and switch for the dash on ebay however I cannot figure out the wiring from the switch to the pedals. I spent a hot minute under the dash/steering column looking but couldn't find anything. Does anyone know if every truck already has the wiring and where it is or if it can be purchased anywhere online?

 

[HSKR R/T]

@Jimmy07 got any advice

 

[MannyN]

There are 2 versions. One with memory seat module and one without.

 

[frisby5]

If this is a easy upgrade i would be interested in doing this upgrade to my BH

 

[bigdodge]

If this is a easy upgrade i would be interested in doing this upgrade to my BH

I thought I got a low buck bighorn, mine has adjustable peddles.

 

[1500V]

So this is connected to a dummy plug that has no pins. It has four wires matching the colors to plug into the motor on the adjustable pedals but I cannot for the life of me find the end that plugs into the switch. I've tried to trace it but it just ties into a mess of other wiring and taped bundles. It looks like in past generation they stuffed it in the steering column when its on a truck without the option but I'm not sure thats the case on the 5th gens and I don't want to commit to take the steering column apart yet without being sure.

 

[1500V]

There are 2 versions. One with memory seat module and one without.
View attachment 208763

Is there a way to get a higher res version of this pic? Its coming in blurry and unreadable.

 

[MannyN]

Is there a way to get a higher res version of this pic? Its coming in blurry and unreadable.

Which one, with or without memory?

 

[1500V]

Which one, with or without memory?

Without memory.

 

[MannyN]

Without memory.

Try this one.

 

[1500V]

Try this one.
View attachment 208926

Perfect. Thank you!

 

[1500V]

I searched all behind the dash and instrument cluster and could not find the other end. I did however find a connector pigtail on ebay that allows me to power/move the pedals that could be used to wire up to the switch or the janky way and grab a battery or something to make some adjustments. My new issue is that it is much harder to remove the assembly than I expected. After some research I found a post that said the steering column needed to be removed when their's was being replaced by the dealer, something I'm not willing to do. So unless anyone knows an easier way to remove the assembly... I have a motorized assembly, the pedal/parking brake trim piece with both switches, and the pigtail for sale.