Disconnected battery, check lights not going away...

[Slutzk]

Yes I know when you disconnect battery I can take up to 24 hours, but its been almost 3 days now and traction control, sos, serv 4wd, check engine light and parking sensors still not going away. I disconnected the battery to mount a auxbeam switch pannel and never went back to normal. Ive load tested the battery and checked voltage and it all checks out good. What do yall think? Anyone had there lights stay on this long after disconnecting battery?

 

[Andymax]

As I understand it, it's not just the amount of time that has passed, but the number of start/run cycles too. I watched when walmart installled my AGM and they did 5 cycles in a row and all my lights were out immediately.

 

[Gren71]

Did you use or get a scammer tool to check the codes?

 

[vtcats]

As I understand it, it's not just the amount of time that has passed, but the number of start/run cycles too. I watched when walmart installled my AGM and they did 5 cycles in a row and all my lights were out immediately.

Curious, did they start and shut off the engine 5 times, or simply push the button put to run, then off 5 times?

 

[Andymax]

started and shut off.

 

[kapinallinen2]

Correct me if I am wrong but don`t you have to have the SGW bypass and a scan tool connected in order to access the ABS module to clear the codes?

 

[Gren71]

Correct me if I am wrong but don`t you have to have the SGW bypass and a scan tool connected in order to access the ABS module to clear the codes?

Ive cleared codes on my ‘23 without the bypass

 

[kapinallinen2]

Ive cleared codes on my ‘23 without the bypass

Me too, just thought that the ABS/stability needed to be accessed through the SGW in order to clear those codes.