Best in channel vent visor? help?

[Kaiser81]

Looking to add some vent visors to the ram. What's everyone's opinion? Mopar? Weathertech? Other.? Looking at in channel ones.

 

[Geddyflea]

I used Mopar in channel with no regrets. The only bad thing is they increase the blind spot at the A pillars.

 

[vincentw56]

This is what I have and they are great. I got them color matched to the truck and looks perfect.

https://www.autoventshade.com/low-profile-color-match-ventvisor/2022/ram/1500

 

[Ruger]

I’ve used AVS in channel on every vehicle I’ve owned they work great and have a nice clean look.

 

[Rlaf75]

I’ve used AVS in channel on every vehicle I’ve owned they work great and have a nice clean look.

I tried those on both of my rams and could never get them to fit properly. I always had a problem with the window going up. I wound up using the stick on's. I'd much prefer the in channel though lol

 

[Ruger]

If you have a problem with the window getting stuck as it goes up. Take a close look at the visor. It will normally be the back rear corner.
It’s because the visors edge is molded with square edges/corners. Get a small file (jewelers file set works great) harbor freight. Leave the visor mounted in the channel, reach in with the file and slowly taper/bevel the corner/edge of the visor. It doesn’t take much. Raise and lower the window until it works as it should. That has always worked for me if I had a problem with the window going up.

 

[HSKR R/T]

I like the ones I have, but can find them anymore. The brand was US Visors and got them off Amazon.

 

[millerbjm]

I've had EGRs for 4 years and they still look like new. Made is USA and great customer service.

 

[Humer91]

love my weathertech set

 

[Malodave]

I have AVS. The Passenger front has a buckle in it and the Drivers side front I have to remount as it started to fall out.
I have to figure out how to get the VHB tape out of the channel first.

Malodave

 

[Belvedere]

I have the Mopars. They look and fit good, but I don't like how the metal clips rub the glass on the back.

I'll second the file. I always file the inside bottom edge of any in channel.

 

[Kaiser81]

I have the Mopars. They look and fit good, but I don't like how the metal clips rub the glass on the back.

I'll second the file. I always file the inside bottom edge of any in channel.

View attachment 144544

I've read about that. That's my only concern

 

[Belvedere]

I've read about that. That's my only concern

I talked to several others who have had them for a long time with no issues, so I went ahead and left them on.

I almost removed them to just take my chances with the tape.

 

[gHiDoRa]

This is the one I have been using.

Product Result

WELLvisors manufactures car accessories from window visors, dashboard mat, sun shade , floor mat to trunk mat. Located in Southern California.

wellvisors.com

 

[ramButz]

i bought these, worked great.just another brand option..your truck your money