Extang 2.0 Fold Tonneau cover install RAMBOX

[Gixxer1kr]

Hello,

Does anyone know how to install this cover on bed with the rambox. The directions that came with this cover are useless (non-existent) and their website doesn't offer any help with this specific install. Looking at the pictures (attached) this is as far as I got. The clamp for the front does not have enough room to twist the knob to tighten as it is too close. I am not sure if I even have the rail on correct.

 

[porkie]

I have the same one. And will post a pic of the front clamp.

 

[porkie]

 

[porkie]

That’s the rear clamp but the front is the same set-up except a knob. Looks like you’re missing the piece that is clamps on

 

[Gixxer1kr]

Thank you! So I have the rail on correct and just missing clamps?

 

[porkie]

yup. As long as the drain ports are near the front of the bed. You will need to take out the cleats to slide the blocks through the rails.

 

[JSBrutus]

Thank you! So I have the rail on correct and just missing clamps?

Could I get some feedback on your experience so far with the Extang 2.0? Like/dislikes? Leaking issues? Overall fit, etc... How about some pics from the outside? I am really interested in this unit and I am curious of its performance and look on the 1500 with Ramboxes. Thanks!!

 

[JSBrutus]

yup. As long as the drain ports are near the front of the bed. You will need to take out the cleats to slide the blocks through the rails.

Could I get some feedback on your experience so far with the Extang 2.0? Like/dislikes? Leaking issues? Overall fit, etc... How about some pics from the outside? I am really interested in this unit and I am curious of its performance and look on the 1500 with Ramboxes. Thanks!!