In a previous post I wrote about installing a RC 3.5” lift kit, but now I think I will remove it and go with a 2.5” leveling kit (2.5” front 1” rear) with new UCAs.
it was really hard to get the front struts installed. I followed all the instructions and have done this type of work before. I’m looking for any tips to make the front strut removal and installation easier.
Would a Mcpherson strut spring compressor help in this case?
it was really hard to get the front struts installed. I followed all the instructions and have done this type of work before. I’m looking for any tips to make the front strut removal and installation easier.
Would a Mcpherson strut spring compressor help in this case?