U
User_9089
Guest
Does anyone have a diagram for the rear bumper wiring?
I was foolish enough when I bought my truck to think the class III would have a 2" receiver so I have to replace it. Class III would have been enough for anything I tow but I need the 2" receiver for my bicycle carrier and dirt bike carrier.
It looks like I will have to remove the rear bumper to install the Mopar class IV hitch because the bumper is mounted to the hitch. With all the sensors in the bumper, there are a fair number of connections to be concerned with. I'd like to figure out definitively if there is a main harness connection I can just pop off and remove the whole bumper, or if I will have to disconnect each sensor and light individually as well as all the harness hangers, before pulling the bumper.
Cheers!
I was foolish enough when I bought my truck to think the class III would have a 2" receiver so I have to replace it. Class III would have been enough for anything I tow but I need the 2" receiver for my bicycle carrier and dirt bike carrier.
It looks like I will have to remove the rear bumper to install the Mopar class IV hitch because the bumper is mounted to the hitch. With all the sensors in the bumper, there are a fair number of connections to be concerned with. I'd like to figure out definitively if there is a main harness connection I can just pop off and remove the whole bumper, or if I will have to disconnect each sensor and light individually as well as all the harness hangers, before pulling the bumper.
Cheers!
