5thGenRams Forums
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
2019 Ram Box Tonneau Cover Pics
- Thread starter AKA BIZ
- Start date
I have no complaints with the factory (Mopar) soft tri-fold. I’ve always used a roll-up in the past (Access is a good brand), but this does the job.
No pic available but I just installed a Retrax mx pro on my 2019 Limited works and looks great. go to www.retrax.com to see the top
Retax is hard Aluminum slides back and rolls into a storage area that takes up less room than the Bak Flip hard trifold I had. Check the videos on their site.
Better than any trifold or roll up I've seen
MX4 backflip
Sent from my iPhone using Tapatalk
2019 Limited 4x4 with ramboxes, no etourque
- Borla cat-back touring with resonator
- 20% ceramic tint all around and pano
- Mostly dechromed and debadged
- Leveled with Daystar spacers and revel links (0.5in rake)
- Nitto ridge grapplers 285/55r22 (34.6x11.7)
Sent from my iPhone using Tapatalk
2019 Limited 4x4 with ramboxes, no etourque
- Borla cat-back touring with resonator
- 20% ceramic tint all around and pano
- Mostly dechromed and debadged
- Leveled with Daystar spacers and revel links (0.5in rake)
- Nitto ridge grapplers 285/55r22 (34.6x11.7)
iamtheav8r
Well-Known Member
I've always used hard tonneaus in the past, but the factory , soft tonneau seems fine for me. Works, is very lightweight, etc.
1JK
Active Member
Did you have the MF Tailgate and if so did you have to lower the BUG tie down rails to get the Retrax to seal against the tail gate? also what did you do with the gaps between the tailgate and the RamBox?
TimW451
Active Member
Factory cover. Once the clamps were fixed so it doesn’t flap, or have a gap on the sides, it has been great. There is somewhat of a gap at the tailgate, which partially better once I installed a BedRug, so it isn’t completely water proof. The trifold folds up nice at the head of the bed and is light enough to lift off when needed. I wasn’t sure about it not being flush, but it doesn’t bother me. This is the OEM option cover , not the MOPAR accessory, which I understand is different.
Last edited:
