2019 Ram 1500 Bighorn won’t start

[Eddierojas]

I have a 2019 Ram 1500 Bighorn/Lonestar. Yesterday afternoon I went to start my truck and nothing. The ignition switch is stuck on off. On the cluster a message that states “press break and push button to start “ duh! But nothing happens. No response from switch. Battery was checked and good. Batteries in both keys were replaced and nothing. All fuses and relays tested. I ordered a new switch but in the meantime are there any suggestions on this issue?

 

[604LMDGUY]

How about vehicle battery?

 

[Eddierojas]

How about vehicle battery?

I had the battery tested and it was good.

Thank you

 

[kapinallinen2]

I had the battery tested and it was good.

Thank you

Can you remote lock/unlock with the key fob? If so, then the fob and the RF hub should be fine.

 

[Eddierojas]

Can you remote lock/unlock with the key fob? If so, then the fob and the RF hub should be fine.

The batteries in both key fobs were replaced and they are also not working. I cannot lock or unlock the truck. I have to use the actual key.

 

[kapinallinen2]

The batteries in both key fobs were replaced and they are also not working. I cannot lock or unlock the truck. I have to use the actual key.

Water intrusion in the back of the cab? The RF hub might have failed.

 

[Eddierojas]

Water intrusion in the back of the cab? The RF hub might have failed.

I will check this. I do have a leak somewhere in the back that enters the truck and run behind the back seat. Thank you.

 

[Brolly]

Hello everyone. I’m new to the community and wanted to know if there was an answer to this thread? My 2020 1500 is doing the same thing. I replaced the ignition switch and it worked for a day but then stopped. Was it the RF hub, Is there a way to test it?