Search results

sorry, it took so long to respond but thanks again Jimmy for leading me in the right direction. **********SOLVED******* Fuse #53 was blown.

Attempted 12in screen Swap on my 2019 RAM 1500 8.4 w/NAV. Like a Dumby a repinned a harness without disconnecting the battery. Now .... 1. wipers stay on while running 2. turn signals don't work 3.streering wheel controls dead 4. hvac controls dead ( hazards work) 5. toggle switches dead (...

ok im going to try to find one .. .thank you guys ... might sell one of my screens if any one is interested

truck is 2019 Yea i thought i had a module I didn't have to buy to by one

radio module behind screen 68307655AG

oh like the radio module won't allow for the 12in .... i can get the part number for the one I have... one sec

i have 2 12in screens

no luck

System IDs

Still the same issue…everything works except the display. Do I need a second Jumper LVDS that attaches to old one?

How’s this look?

This is the other connector

Minus the hazards…I took it back out to switch to my old screen

Do I need to repin more than just the hazards?

Actually it doesn’t

ok luckily i have 2 screens i can test with... I'm going to go over all the steps one more time. At what point should I plug up the screen, before the programming or after ?

The Config in AlfaOBD is done, i just wanted to make sure everyone was recommending the same settings. LVDS cable is the factory cable and the OLD screen still works with it. so I don't think its a bad cable. Im going to fully install it with a bezel and everything and try to discount the...

Is there any other small things i might have missed? like a hard Radio reset? or maybe it needs to be fully mounted before it turns on . i have been just testing with the screen by itself no bezel with only the LVDS cable and radio cable connected. I also still have the bypass still hooked up

Its that in 1. 2019 PowerNet 2. DT 2019 PowerNet Var.1 3. DT 2019 PowerNet Var.2 4. DT 2019 PowerNet Var.3 5. DT 2019 PowerNet Var.4 or is there another one?

if you are talking about the white cable right next to it then yea. 1.what settings should I use for the 12in in ALfaOBD if I have 8.4 w/NAV