Search results

In the fuse panel below the steering column. The 2019–2023 Ram 1500's 12V outlet can be switched to either ignition power only or always on by changing the position of the fuse in the cabin fuse block. The fuse block is located on the driver's side panel, under the steering wheel, behind a 7...

The big e commerce site (ends with bay). It’s a 12 Volt Accessory Power + Ground T Plug Connection Cable for Some Jeep/Ram/Fiat. It was right around $20 shipped. Sent from my iPhone using Tapatalk

I ordered this power adapter to plug in-line with the accessory power plug in the tray above the radio to power my front cam, just make sure you don’t have that accessory plug set to constant voltage, if you go this route. Sent from my iPhone using Tapatalk

I’m still waiting to hear that someone has successfully gotten this to work in a 2019. Sent from my iPhone using Tapatalk

What year is your Ram? Sent from my iPhone using Tapatalk

Any luck on getting the switches themselves to activate on a 2019 yet?

I have that same switch panel. No reason it wouldn't work. The last switch should work the same way internally, whether it says Aux 6 or PTO.

Yeah. I’d be willing to test any device that someone can create to make the switches work on 2019 & 2020 Rams. My switches are installed and I’ve completed the update to the Uconnect 12. Just need the switches to come online.

While it is great news for those with a 2021, it doesn’t help those of us with 2019-2020 trucks. I’m guessing no one else has made any headway on this for those of us with 19’s and 20’s.

New update. The good news: After following the steps that TravisH posted and leaving my truck parked overnight the aux switch option now shows available in the settings menu via the radio. The bad news: I can not make any selections for the switches (momentary, latching, battery or ignition...

I just tried these settings on my 2019 Ram Rebel with no success. I used Alfa and changed the following: 1) ASBM Present: yes 2) Auxiliary Switches CSM Present: Switch 1-4 then cycled the ignition from run to off several times (4-5) and no illumination from the light on the aux switches and no...

Here’s a copy of my order form from the company that I used to get the needed connectors and pins.

There’s the pin out and a picture of the “jumper harness” that I created. I don’t have the part numbers right now, but I can post them once I locate my order form, from when I ordered them.