Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I haven’t in my Ram yet (will be doing so next month) but we’ve driven our Land Cruiser on the soft sand of the OBX beaches quite a few times and I think your tire selection isn’t as important as is adequately airing down to get a bigger contact patch and help you stay “afloat” and not sink...
The posts saying that it’s not possible are accurate. I have a non nav flat black bezel and I bought a gloss black unit and tried to make it work. The mounting points of the gloss black bezel for the nav screen are completely different on the back side. It will not work unless you get a new...
Got a 4th kid on the way so need to be able to haul 6 including me and I really only cared for the rebel trim which got me stuck at 5 seats till I did the swap.
I made a separate thread since my write up was pretty in-depth. Can be found here: https://5thgenrams.com/community/threads/center-console-to-bench-seat-swap-complete.6987/
rlc2020, glad to hear you got the USBs working!
The next picture shows how the wiring of the back USB hub, you will need to disconnect each of these. The one with green wires if for your traditional outlet, while the other two are for the USBs.
Once everything is unplugged you will want to cut the original wiring harness at the location I...
Wanted to get this recorded for anyone else that wants to take the plunge. I got all my parts from another forum member rlc2020 who gave me his center jump seat and all supporting parts in exchange for my center console (his write up is in this thread ...
Bingo, that last observation I made about switching that wire to mimic the original setup (as opposed to the setup from the new wiring harness) was correct. EVERYTHING works now just like factory! I'll snap some final pics and clean up the wiring and get my truck back to normal. I'll try and get...
Quick update on the progress of my bench seat swap/install:
I got the wiring harness in, part # 68362132AC which i *believe* is what I would have had with the original Rebel floor console. Every plug matched perfectly to the new lower center console trim and the back USBs/power outlet with the...
From my end of installing the center seat into a console truck, I was able to plug in my existing wiring into the seat which gave power to the back seat USBs and the power outlet, so a win there, but it left no way of powering up the new USBs and power outlet located in the center lower dash...
Me and member rlc2020 are in the process of doing the swap now. He’s got my console and I’m getting his seat. Apparently he’s gotten the console in but it took some wiring work. I’ll let him chime in on his efforts. We are swapping front carpets as well as the other obvious hardware because the...
Just had my magnaflow installed over the weekend. Like the low, deep tone, not much bark on startup if it’s already warmed up, WOT is a bit disappointing, sounds good to about 3000 RPMs but the sound seems to level out at that point and not increase in volume with the rpms. Barely notice it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.