Search results

So I just finished adding the power folding door mirrors to my 21 DT 1500 and programmed through Alfaobd. The mirrors fold in fine and the turn signal indicators in the mirrors also work fine.... Have not been able to get the puddle lights to work, but that's not I big deal. After the...

I'm looking to add the floor storage bins to my 21 1500 DT. Does anyone know if the right and left are interchangeable? I'm showing a few on Ebay, but they say most are for the passenger side. Will the passenger and driver side interchange?

Does anyone know if there is a difference between 2021 1500 Classic with 5 lugs front shocks Vs the 2021 1500 DT 6 lug front shocks? I have an opportunity to buy a new set of Bilstein 5100 front leveling shocks, but not sure if they would fit as the Bilstein website says they are for the...

I recently had a local shop replace my radiator due to a pinhole leak in it, could have done it myself, but had a busy week and no time. It's a 21 1500 with the 3.6. It had the original coolant in it (purple), but when I got it back, the reservoir shows a fluid that is not purple, but an off...

Can someone chime in if I am wrong... I have a 21 Bighorn 1500. I upgraded to the 8.4 Non-Nav Uconnect 4 radio. I wanted to add the front camera, but from reading all the post on this, it cannot be done because I have the 8.4 Non-Nav unit? Is this correct? Hoping it can be added as I already...

Do you need to have the 12 inch screen in order add or view the off-road or Performance pages? I currently have the 8.4 Uconnect 4 and 7 inch EVIC in my 21 DT Longhorn. Can they even be added with Alfaobd or Jscan ( I have both).

Looking to add the Muzzy A/C valve “hack” on my 21 1500 with the 3.6. Been searching and cannot find which hose is the “in” to the heater core on the 3.6. Can someone help identify? The attached photos are the heater core hose. Is it 1 or 2 that is “in” to the heater core. I followed the lines...

Can AlfaObd or Jscan make corrections to the engine and idle hours to a 21 1500 with the 3.6 etorque ? I'm about to do the speedometer swap and not sure if those can be adjusted. I know they do the mileage.

I have a 21 1500 with the 3.6 Pentastar. I know these are prown to the coolant leak smell. I noticed that there is a leak from the heater hose connection. I traced it to the quick disconnect. Can that quick disconnect be bought separately or do I need the entire heater hose. Can't find the...

So I finished installing the passive lock system and the install was easy and functionality works. The only issue I'm running into now is the truck threw up 2 CEL, one for a P0073 code, ambient air temp, I thought I cleared it with a scanner, but it came back. The other message is the Start/Stop...

I need to replace the thermostat housing on my 2021 1500 with the 3.6 Etorque. Plenty of online videos for the 3.6, but can't find anything for the 3.6 with Etorque. Has anyone on here done it and how difficult will it be. Does the MGU need to be removed as that is the only thing that really...

Looking for advice on what to troubleshoot. My 2021 1500 with the 3.6 will sometimes throw a P0128 code (low coolant temp). I run my scanner to clear it and it goes away. After doing this a few times I have noticed a few things on when that code returns and It only comes on when I am running my...

I'm looking into swapping out my 3.5 inch cluster to the 7 inch on my 21 DT 1500 with the 3.6 Pentastar. I've located a cluster, but it is from a 2021 with the 3.0 diesel, VIN#1C6SRFKM3MN530500, will the diesel cluster work on my gas vehicle?

I just upgraded my 21 1500 DT from 5 inch to the 8.4 screen. I purchased a used 8.4 full stack, but the unit came out of a 21 Laramie with the Auto temp AC controls and heated seats and steering wheel. My 21 1500 had the 5 inch with single zone system. I installed the unit and it was pretty much...

Hello, all. New to Forum. I'm looking into Alphaobd to make and change options to my 2021 1500 DT crew cab. Reading through the threads,I'm a little confused on what physical hardware is needed. I know I need the app and an android device and the OBDlink MX+. Where I'm not sure, is what I need...