Search results

You might have better luck posting in the appropriate section. This is the new member introduction area. And as to your answer, it does a lot. But doesn't provide power.

Welcome. Keep in mind this is the 5th Gen 1500 Rams site, but you are welcome here. If you have questions, you might want to post in the 4th Gen sections.

You might have better luck in the Homepage - HD Rams forum. This is the 5th Gen 1500 Rams site.

It won't.

They won't say because you need dealer level tools to do it. You can make the changes in the BCM, but then you need to run a proxy alignment. Unless you have a lot of money, you can't do it like before.

On a 2025+? Not happening any time soon.

You might have better luck in the Homepage - HD Rams forum. This is the 5th Gen 1500 Rams site.

Will they lock and just not unlock?

Since you can't program the BCM on a 2025+, I don't think you are going to be able to use it.

The handle doesn't matter. You don't need a special handle. You need the rear antenna installed.

It probably got moved to the appropriate section. That happens sometimes. Did you post here Homepage - HD Rams forum.

https://5thgenrams.com/community/threads/how-to-add-adaptive-cruise-control-lane-assist-fcw-auto-hi-beam-to-ram-1500.30924

There is a write up on this in the modifications section. But, yes, they are there already.

That comment doesn't make any sense. So, if it works without the adapter (doubtful), then why use it?

The adapter is doing more than just providing power. Power is already there for the mirror. Do you have a link to the adapter or where you bought the mirror?

There is a door harness that you can run it through. If you need more details, look into the thread about adding passive entry.

There are lots of options on here. Just do a search and you will find them. A lot of people put little puddle lights under the bumper and wire it to the trailer wiring.

Any info about that adapter? Like a link to it? It must send the same signal that the BCM does.

"If you have a tool for depinning connectors, slide it in the terminal positions from the face side of the connector (photo directly below) and the plugs will push right out. If you do not have one, a small piece of wire or a paperclip will likely work just as well."

I think your post is incomplete as it doesn't make sense.