Search results

Wow, thank you. I've sent a request. I have a friend in Germany who would forward it to me if they won't ship to US. Maybe a day. I've checked and the 2 required wires are present in my cabin harness (amazing since this option would never be installed in the US). I've bought a bumper...

Yes, I have 68338768AD. SAE F2 19DT FCA in on the lens. There is a large L on the back, on the housing. There's a mounting pin on the left side of the light. I'm guessing the pin would be on the right for the Right PN. I'm sure I could make a Left into a Right; but at this time, I can't even...

I've not done it yet (still hoping for find the Right lamp); but I've found out that that you have to have the 2 wires present in the body harness, at the connector that goes through the floor. I think they're WH/DG and WH/OR; but check Jimmy's post to confirm. I've already installed the "4...

I didn't document the changes; and don't remember. The changes you listed make sense. I don't think I set Seat Material. What are the options, and what is Type 4?

I had to buy the end cap also. Found a used one' but it was still expensive.

I've obtained almost all of the parts. I have the headlamp switch (with F and R symbols), the bumper wire harness and the Left fog light. I can't find a R fog lamp anywhere. All the parts sites show the fog lamp as available; but they don't actually have it. Where did you get yours? Thanks...

Yes, I had to flash a few things to enable Heat and Vent rear seats

Mine is slightly below the mid point (30) at idle. I wish it would be at the mid point (just for piece of mind); but I guess it's OK.

My truck already had Auto AC, so I don't know. I would suggest swapping the center stack and seeing if it works. If not, then flash with ALFA. I have this one for sale on eBay. 8" Ram Center Stack Climate Control | Part no. 68340286AC and 68340286AD | eBay

It is an integrated part; clock spring and combi switch. My issue it that I had to replace the part when I installed a heated steering wheel. They don't "give away" the extra 2 connectors with the standard part. The part with the extra 2 terminals (AA engineering change lever) has been found...

I just received a recall notice on a completely separate issue, ABS Module Configuration Mismatch. I took my truck to the dealership. Was told the software is not available yet. While I was there, I brought up the turn signal issue. I was totally open; I bought the Multi Function switch...

Original Multi-Function Switch part 68545657AA was around $300. Engineering change level AB , which supersedes AA, is around $70. I guess I should just buy AB; but it sounds too good to be true. Any information? Thanks, Brent

To clarity, there are no additional wires required to add the center stack with physical buttons. The center stack is CANBUS (or whatever it's called now) connected, so it's plug and play. The 3 wires I talked about send Fused Ignition to XY420A (big yellow seat connector). I THINK these 3...

I see the link doesn't work. It's for the FB Marketplace 5th Gen Rams Buy/Sell/Trade. I also have it listed on eBay. It's the Center Stack with the heated seat switches. 8" Ram Center Stack Climate Control | Part no. 68340286AC and 68340286AD | eBay

I'm searching for a better diagram; but I'm fairly sure I had run 2 (maybe all 3) of the PK/YE Fused Ignition (Pins 1,3,5 of XY420A (PASS on the screenshot) across the IP to ASSEMBLY-POWER DISTRIBUTION CENTER-INTERIOR C3 (Pins 17, 6, 27 and circuits F921, F924, FF922 , respectively) . These 3...

I have this part for sale, if you need it. Log into Facebook

When I bought my seats, I told the junk yard that I'd buy them only if I could get the wiring harnesses. I didn't know the configuration of the harnesses; but found out that there's a Cabin and an IP harness. I got both harnesses from the donor truck. After I paid them $200 to pull the...

Not directly related to this thread; but the heated/vented passenger seat I had swapped into my truck was "tweeked" from the wreck. No damage to the exterior of the seat; but it leaned about 2" toward the center of the truck. I had tried pry bars and a come-along to straighten it. I helped...

After I installed the new clock spring (Steering Wheel Module) in order to make heated steering wheel work, my left turn signal stopped cancelling. Found out there was a batch of faulty parts, with the AA design level. There's a recall of some 23 and 24 trucks with the bad parts. I won't...

I'm not the OP; but I have some input. Earlier, I swapped heated/vented power passenger seats into my 2022 BH with Level 1 Equipment Group. I had to add a lot of wires to my truck. Once I swapped a center stack with heat/vent switches into my truck, those switches worked without any flashing...