Search results

mine died after a day of sitting. I changed both batteries with non mopar. I only notice that the charging range usually stays near 14.2-14.4 (usually pegged near 14.4) when driving and with key on engine off it will show the voltage drop from that to 12 sometimes 11.8 ish. Not sure if that’s...

My battery

It w it will probably take a couple drive cycles for the battery sensor to do it’s thing with the stop start. Glad it’s running again!

Thanks 🙏

Can any of you guys tell me with key on engine off the voltage you have? Are the numbers displayed in red? Thanks

Could it be the high current fuse array? It’s the set of fuses at the end of the box with nuts on them. It’s a one piece replacement for a bunch of fuses connected to the batteries , alternator, etc

I might have been the location of your key fob, I’ve heard cellphones if close can mess with it, or maybe the fob has low battery?

That’s with the truck on but not running correct?

Same here sat for a day dead. Put 2 new batteries not mopar

I let mine sit and didn’t drive for one day, batteries died. Was at 2v. I changed the batteries myself both main and aux. hasn’t died but in the run position the battery voltage shows at 12v in red. Does anybody else’s voltage in red or is showing a low charge?? In running position with truck on...

Both

Can anybody tell me with the truck in run position if the voltage on the dash is red?

How’s that 6inch lift feel when driving, highway etc. I’ve been looking at it

Mine is red and drops to 12.1 volts new batteries

When you put the truck in just run or acc mode does the voltage show as a red number or white??

Thanks

I don’t know if this killed my battery one day. It was 2v. Replaced both batteries get a check engine light , engine off ignition on Turns off when started At stop start events my voltage drops to 12.2 12.3 and it is in red as if it doesn’t like the voltage No codes Any help appreciated

So I went out a couple weeks ago doors wouldn’t unlock, no start battery was 2v. Replaced both batteries and truck has all power but when turned to run position I get a check engine light. Once running no check engine light. At a stop start battery voltage drops to 12.3 which isn’t terrible...

Did you ever figure out this issue I got that code as well

Looking to replace my battery. Can someone tell me the types and cold cranking amps needed on the main and aux battery. I appreciate it.