Search results

PAC Amppro will not work with basic 6 ch system as there is no Amps.. In either case, w/ or w/o factory Amp., and you intend to add aftermarket speakers & Amps, still better to take your feed directly from factory radio to a DSP and bypass any factory amp. This is one less conversion and...

If you want to maintain all 6 ch’s In basic Ram config, your 4 ch amp will work. I would put a DSP in front of it as you will need to tweak tuning with factory radios. However, unless you plan to add a sub and speakers that require power, (bigger amps) I would leave in factory mode, maybe do...

Don't be paranoid. I have an Alpine X209 w/JL Audio amp & Morel Speakers in my Jeep. The factory system in my Truck w/ the FIX 86 feeding my amps sound as good or better than the Alpine in my Jeep. In fact, you will get a cleaner output with FIX than using the PAK simply because the PAK would...

No need for the PAC-Pro if you want competition level and retain your factory head unit. Go with the JL Audio FIX 86. Run the 4 high levels from factory radio into the FIX 86. Thae FIX will sum everything and give you a flat output to drive your amps. I would go with an amplifier you can tune...

Hi Folks,, Kirkelli again.. I forgot to mention the best part of my install with the VXi Amps and wanted to make sure some of you are aware of this. The VXi amps accept RCA and or Fiber Inputs and are switchable by a digital remote control accessory for these amps. When i installed the...

Netaudio will fix you up with a load only harness. They will do almost anything. talk to them.. Great People. I think they even make a Harness specifically for Ram and the Audio Control unit.

Yes, very easy. remove dash speakers use a long plastic zip tie as a fish from top down.. route your wires under kick panels left and right. i ran mine to the rear behind second seat. There is also lots of space under a hidden panel in the center hump area. Ran my power cables for amps in...

The Harness connects from between factory radio and the factory harness using same factory male/female connectors. The harness basically provides a clean way of taping into the 4 high level outputs directly from the radio with no need of cutting into anything. It is my best guess that the...

Hello All, Been following this thread for awhile and thought i would share my install. I have a 2018 Ram 2500 w/8.4 RA3 Radio (6 speaker non Alpine w/NAV). I do not have the ANC in my system. I am a very long time audio nut and need to have good sounds in my vehicles. After getting my Ram I...