Search results

I took my '21 in for the DEF Recall, Trailer Steering Recall, and to fix the Rear Parking Sensors that stopped working 4 months earlier. The Software fixes were not talking to the BCM. I spent 10 hours at the Dealer's Service Department that day. Hopefully the High Pressure Fuel Pump Recall...

I need to extend the Tongue on my 8.5 x 24' Cargo Trailer. It interferes with the Blind Spot Sensors. Malodave

There is a 131 Page Guide that was posted above with the Procedure for just the pump and the procedure for replacing the whole fuel system. Malodave

I will do a complete How-To post on it soon. It was easier than I though but you will need a GOOD Soldering Iron with lots of heat. A 25 watt pencil Iron will not cut it. I had a $600 Metcal Iron and it was difficult to solder to the PCB. The Solder holes are not Thermally Isolated, that's...

I took my online build sheet to the dealer to order the '21 Laramie. The Salesman added the Cold Weather Group for me as he thought that was for the Heated Seats and Steering Wheel. There were a couple of more things that I would have ordered, but they were not offered. Like the Limited's...

Depress the Black tab inside the white Lock. Malodave

I have been using a Sandisk 128GB Thumb Drive with MP3s for the past 3 years. Only had one hiccup with two inputs going into the system. After a day it corrected itself. Malodave

I thought it was strange too.But it could hurt your night vision if it did that. Malodave

I had that happen on my 2008 Big Horn. It turned out that the plug to the light switch was not in all the way. So the Truck's BCM defaulted to the lights being on. Malodave

I am coming up on 61K Miles, but I have been using Hot Shots EDT since new. Malodave

I am Welding two 3/8-NPT Bungs (Fuel & Vent) between the tank and the filler neck. Drilling a hole on the inside bed wall for a grommet big enough to led the two lines pass. I have a Transfer pump with wires going into the cab and up to the Overhead console where I installed 6 switches for...

I ordered my '21 Laramie with the 33 Gallon Tank, But I am still adding a 72 Gal Aux Tank in the Bed. So 105 Gallons of Diesel on Board. Malodave

I am hoping for that too. I have a spare PCM to be cloned after and when I get back near Detroit. Malodave

I have not done anything to mine on the '21 Laramie in 3 years living in NH. Malodave

I also have some "cling" tint to put on the side window to help with the bright lights of other cars coming from the side mirrors. It just peels off if needed and can be reapplied. Malodave

At Night I find myself trying to look under the tint to see, but then i realize that it is the Headlight beam cutoff I am trying to look under and not the Tint Strip. DOH! Malodave

You will have to pull the console to even start a diagnosis. There are two screws inside the Sunglass cubby to remove. Then there are two clips to depress. The console should drop with two harnesses going to connectors on the console. Malodave

F11 is for the Clearance lights. There are no contacts inside the TIPM. I will be pulling mine to solder a inline fuse holder for my Cab Lights I added to my 1500. The Red circle is the side of the fuse that gets power with the Running lights. Malodave

The TIPM is the Fuse Box under the hood. (Total Integrated Power Module) Malodave

I designed my own to go on my '08 Big Horn 5.7 Hemi. It mounts a York 210 AC compressor to the Engine. I had a ViAir 380c. It took 23 minutes to fill my 9 Gal tank to 200 PSI. The York could do the same in 3 minutes at Idle. I have a Sanden AC compressor to put on my '21 Ecodiesel and have to...