Search results

Looks good, keep us posted on durability.

I'm thinking about doing something similar, what type of prep to get it to adhere to the wheels?

I added Kickers to the dash, front doors (mid-bass only), and rear doors. Also placed Rockford Fosgate tweeters in the A pillars. I haven't replaced the center dash or the rear roof speakers yet, but I'm satisfied so far.

Alrighty then, you wanna do mine?

That's badass! Did you have to use heat?

78 miles and your transmission had to be replaced? Damn.

The wet method is the most forgiving, allows you to move, redo.

I had a few rolls hanging around and put them to use.

They were just begging to have something done to them.

Covered my door pillars to match the RAM logo on the doors. With so much time on my hands, what do I do next?

What's the interval on those?

That's a good looking truck, lose the Alabama plate and "Roll Tide" and it will be a great looking truck. Geaux Tigers!

I don't have the factory bed lights, if I pop the cover is there a prewired harness?

Installed Redline LED tailgate lights. The space to mount is not flush, i.e., tailgate harness cover, so I used spacers. The two ends near the taillights are angled. wtf. Did anyone build the ends up to mount the lights on? Thanks. Special thanks to dts828 for your guidance!

I got it, everything is working as it should. As I look at it, I think I will mount an aluminum bar and then mount the light strip on to it. The tailgate harness and the other non-level areas is not clean enough for me, spacers were used but still too wavy. Thanks for your assistance.

Installed LED bulbs in my third brake light and K&N cold air intake.

I think I have the wrong harness Curt 55384

What adapter is this? I want to hook up tailgate LED with no cutting. Would like to have reverse, turn signals and brake lights operate. Will I be able to accomplish with this adapter? Thanks for your input.

I got my LED tailgate light bar. Reading different paths on which way to install, some use 4 way Curt, some use 5 way Curt. I want to be able to install with reverse lights, trying to figure the proper spacers I may need and little to no factory wiring splicing. Looking for the best route to take.