Search results

How long did install take? And was there enough room to get in there without taking the tire off? also curious if you had to switch the positive and negative wire around , some videos I saw said you have to do that or test them?

Let’s see some pictures how it turned out!

it fit without issue ? And which model did you go with?

I was going to get a h7 agm to replace my stock battery, but I heard some people upgraded to a h8, is that the better option to go with?

Do you know which part you need for the bezel and brackets?

Let me know how it works please, I’d like to get these and put them in mine. I have the open mesh grill I put the hidden lightbar behind it

Not my pics but what I used and how it looks with this seal on. No more foam and it hasn’t leaked. Much better than oem seal.

It’s not bad, I took a little heat to it and 3m wheel to it and put on the new seal.

Any idea if these will work with trucks with sensors? I have a limited so it has quite a few sensors in there.

What do you guys think about taking that seal off and putting an aquamarine type seal on it? That’s what I did with my oem one, much better seal that the foam one that comes on it.

thats where im at i put in the see through lower grill just now and i prep for the lightbar getting here, im trying to figure out how im going to run the wire into the cab?

Thanks for the pic that helps- so for the RC switch it looks like it’s just a friction fit if you cut the size right?

Any pictures of how you mounted the switch in the cab

do you have a picture of this setup, im currently trying to figure this 5 pin connector out right now

If it did then what? I have to purchase a whole new mirror ? 🙄

I was replacing mirror caps and apparently I pulled a bit to hard and one came out when the mirror pulled off. The black housing their in I opened that with a tab

Okay cool, I’ll have to look for that tomorrow, I didn’t see one inside the black housing they went into, but I also didn’t look close, so it prob is in there

I don’t but I looked them up and I’m pretty sure you are correct they are molex a male and female

These are the connections for reference I’m referring too

Does anyone know how these blind spot connections go back in the clip? I changed my mirror caps and on both sides these pulled out and Not sure if they clip in or how they go back exactly, picture for reference of what I’m talking about