Search results

Why didn't they just write that? It would've made much more sense.

Fadfirst?

Not unless there is there is a load on the wires.

You can get non-oem on the bay for little more than $300 for the pair. They're like oem except no RAM molded into the plastic.

Check for sure, but I'd bet the pockets are 1" too. Check the studs too.

Front

Thanks! No, I didn't have to cut any studs. Both, my night edition 20" wheels and the rebel wheels' pockets are 1" deep. There was at least 1/8" clearance with the 3/4" spacers. I confirmed after installation - no contact and drives as good as before spacers.

Here's my bighorn with OEM 18" rebel wheels. I put Bora 1" on the rear and 3/4" on the front. There is some poke, but these tires' treads aren't as wide as the overall tire width, so the tread doesn't poke as much as the whole tire does.

Or just a CAI and TB spacer.

Luck for me too. I bought OEM sensors for my rebel wheels. They responded within the first 1/2 mile of driving.

About 7500 if I make sure to drive it. Working from home with 4 vehicles limits my mileage.

Hi! Nice looking truck. There a lot of knowledgeable people on this forum. It's better than what I heard about it before I joined. It really is like a big family filled with warmth and love.

You can always carry a jerrican with a few gallons of gasoline. Run your truck empty and just add a gallon or two to get you to the gasoline station. Then fill it up and see how many gallons you added. The pump fill-up plus the measured amount you poured in from the can should be close to your...

How do you wear out a sway-bar? Is it the front or rear end-links that are clunking? Maybe just try OEM front links for now. Core 4x4 rear end links are a great alternative, but I don't why any other rear end links are going to wear out or start clunking in 1000 miles. Do you drive rugged...

With the tank in place, you reach up and on top of it and re-connect the electrical connector to the fuel pump assembly. Maybe the contacts are oxidized and not making a good connection. Read up in the thread below and study the pictures. You'll be working blindly, but it's not difficult. If...

Yes, that one too! I did change that one. I forgot about it.

FWIW, I removed my AAD. A code was set without a CEL. I cleared the code using Alfa one time and have never seen it since the first time, following removal.

These are the lights I ordered. If you look closely, you'll see the cover in the pictures. It's pretty flimsy, but doesn't matter because you'll just throw it away. The price went down considerably since I ordered them! What a deal. There are other OEM-looking lights that do not provide this...

https://5thgenrams.com/community/threads/performance-pages-on-2022-limited-12-inch-uc5.46211/#post-762473 https://5thgenrams.com/community/threads/removing-cell-modem.50759/

It this about the Active Air Dam (AAD) or Active Grille Shutters (AGS)?