Search results

Fallen wildpeak at3w got 90k out of the last set between two trucks cross rotated every 5k. Just put another set on went 285/65/20. Had Discount tire price match Walmart. Sent from my iPhone using Tapatalk

I have used ceramic infused AIO polishes (McKees 37) with good results, and would only use polishes if you plan on having the truck long term. I use both microfiber and foam pads. Preference is meguiars microfiber pads, and anything from buff n shine. This paint is scary thin. Also your clear...

Use a small metal mallet. The dead blow does not provide the vibrations to do the job. You don’t need to go ape on it. Just solid taps. I started with a dead blow and whaling on it to no avail. A fraction of the force and a couple taps with a metal one popped it free. Sent from my iPhone...

They would have to know the precise wire schematics and routing to the tailgate. They are not going through that trouble. They would more than likely just cut/break the tonneau cover, or bust a window. There are 2 wires to the driver side actuator and 3 to the passenger side. The passenger 3rd...

If the fob is dead there is a valet key in the fob. Manually unlock the driver door, then power unlock the vehicle to unlock the tailgate. If the truck battery is completely dead (ie. Door unlock doesn’t work) you will need to charge or replace the battery. Otherwise you have to remove the...

Looks like a poor coating job. I have 95,000 miles on my 19 and it does not look like that. But if you think that is bad you should take a look at the 2021 F150 debacle with that. I chalk it up to pushing production out the door to meet demand and poor oversight on quality control. Sent...

Turn the temp dial one click to the right, and if the recirculate light is on push the center to turn it off. When your turn it to max cold temp I auto turns on recirculation, and max won’t let you turn off recirculation. Sent from my iPhone using Tapatalk

Compressed air. Either shop air supply or even the little cans. If it has spots after I use...

The top of the plastic Chanel casing pops off. Sent from my iPhone using Tapatalk

The 6’ bed was a must. I had the 5’ for 3 months(long story) and it drove me nuts I couldn’t close the tailgate with a 6’ ladder in the bed. Plus I think they look more balanced in over all appearance. Sent from my iPhone using Tapatalk

Here you go. I just didn’t trust plastic. https://www.amazon.com/gp/aw/d/B08L5V9QST?psc=1&ref=ppx_pop_mob_b_asin_title Sent from my iPhone using Tapatalk

20x9 -12mm Pro comp Rockwell’s Aluminum Hub centric rings 285/65/20 Falken Wldpeak AT3W Rough Country rear wheel well liners I ceramic coated the wheels before install. I also cleansed the rotors of surface rust, and applied a film of anti-seize prior to the wheel install. I have a 2.5”...

No, but can’t hurt for road trips. That’s what got me. I was going to get PPF done when I bought the truck. However, before I could I had to attend a funeral 6 hours away. Ran into a snow storm and when I got home it it looked like I got hit with a couple rounds of buckshot. I am past the...

Big scam, here is the manufacturer guideline https://www.dropbox.com/s/zu1bvwv5yjf0w0d/Fluid%20Flushing%20Requirements.pdf?dl=0 Edited for correct link Sent from my iPhone using Tapatalk

The paint on these Rams are stupid thin. I forget what reading I was getting from my paint thickness gauge when I bought it. I do remember the reading was in an area that was shockingly thin. Sent from my iPhone using Tapatalk

Look into starbrite salt off. I will dispense it through my foam cannon or a pump sprayer. Let it dwell to dissolve the salt then pressure wash it off. I hit the under side and fender wells also. Then do a rinseless wash, two bucket wash, or last resort drive it through a TOUCHLESS wash (only if...

Sure have. I grew up in Golden Beach and worked at Bob Green Siding through High School and summers from college. Still have all my family there. I live in Tennessee now. I miss my Crabs, oysters, and Chaptico Markets fried chicken. I figured that was it given your screen name being a 7D staple...

Is this the same Ridge that the gestapo tried to shut down in SoMd? Sent from my iPhone using Tapatalk

Also the Laramie has power passenger vs manual on the Bighorn. Sent from my iPhone using Tapatalk

I understand how it happens. It is not just from the solvent flash, but also from air pressure and spray pattern. It can, and is done intentionally. Body shops do it all the time when fixing panels to try and mimic the factory texture finish next to them. The Orange peel hides the imperfections...