Search results

Would really need a padded backrest for that I think. For a 10" sub, the lows are decent, a little sharp & snappy though. Th L7T models do not extrude or push as much air as the others in the Solo line. Now that I've built two boxes for the same space, I know that I can add a bit more internal...

I cant remember a time where I've had more than three people in any of my vehicles at once (including myself). But I get your point, it sorta bugs me too. I've made a few alternate covers, four so far. They are each held in place via Neodymium magnets, so easy to swap. While I do like the...

Didn't you already start a thread on this question here? Also a reminder to fill out your sig line with basic info on your vehicle, so people know how to properly help answer your question.

From my understanding the older DS and Classic design trucks need some sort of in line resistance similar to what kicker offers, perhaps not the DT models? Not completely sure, hopefully someone with V6 experience will chime in. I found in needed something to clean up the signal and not a load...

I am new here also. Filling out your sig line with your truck info will help a bit with future questions. Hemi or V6? Classic (DS) or new body design (DT). If you have the DT V8, non alpine, non HK, standard 6 speaker system, I may be able to help. The others not so much. If you do have the...

I'm a mixed bag for smokes depending on my mood. As you can tell by the gear in my box (the cutter is great, lighter sucks), I used to be a dedicated Romeo+Julieta guy. They still have a few decent sticks, just fewer and father between, and not really what they used to be. Currently I have a...

I "murdered out" the interior own my own (I've worked in automotive paints as a hobby for years). I took apart what could be dissembled via screws or tabs, prepped and painted those parts with House of Kolor BC25 Black & clear coated them. Some parts are easier than others to disassemble (center...

I didn’t want to invest in a console safe that technically uses the factory plastic sides and floor to protect my valuables (and I'm cheap). So I installed a portable electronic safe box with a cable. I removed the console bolts/screws to slide it back for access, drilled a hole in that odd...

I have the 6 speaker base system, which I replaced all speaker with Infinity Reference series (originally bought Kappa’s but they do not fit in the doors). I may upgrade to Focal later, though so far the infinities sound decent enough. The Hemi meant I have the ANC under the driver seat. I...

A few parts are wrapped with Vivvid vinyl due to the type of plastic the parts are made from. 90% of the parts are painted, which had to be block sanded (the sides of most of the aluminum and plastic bits have a rough texture). Primed with an etching primer, then painted with House of Kolor BC25...

Only the door handle covers, climate control knobs, and dash speaker grill outer rings are vinyl wrapped, the rest have been painted.

Upgraded my sound from the base six speaker system to something better. I managed to fit a Rockford Fosgate 750-1D and a RF R2-500X4, plus an AudioControl LC2i Pro, all under the front driver seat. My goal was to keep the new audio gear together, and with as short a run for electrical wiring as...

Cutting the catches will work. When cut correctly, raising the lower seat at a 45 degree angle will lift the rear enough to free the back to fold forward. There are a few vids on YouTube that demonstrate this. Another option is to lift the seat with spacers. This requires no permanent mod to...