Recent content by WildWildWest

I recently started having the same problems. One day: attempted to start truck, electronics went haywire with crackling in speakers, failed to start. Had the truck jumped, all was good besides CEL. Had the battery replaced. Truck continued to drain battery overnight. Finally saw the...

You have me considering just doing the wiring harness now instead of hard wiring. No sales code had to be activated for the light to work?

Just ordered everything. Is it pretty self explanatory to mount? I’m assuming I pull trim piece from location, replace with new trim piece that allows for light mount. Screws go into light, screws then go into nut and they attach to the new trim piece? Are my assumptions pretty close?

Appreciate the info!! I’ll be looking further into this for sure.

Ahh didn’t know about a plastic mount! Any part number by chance? I was just going to hard wire it instead of messing with harnesses. Did you have to drill holes to mount?

Looking to see if anyone has installed the 3500/TRX rear center marker lights on their 1500? Part number 68362184AB Plan to wire into trailer harness adapter that I got for my reverse pods. Curious if anyone knows if it’s a direct mount or if I will have to drill holes? I’ve seen talk about...

Did my take on what I wanted for reverse lights using various methods found on here. Used the referenced Curt adapters. Wired to reverse lights and on a switch wired to constant power. Wired in bed lights as well, all feed to the trailer wire harness. Used 3.5 inch pods mounted on tubular...

Grille arrived. Mesh is color matched to truck.

Thank you! Unfortunately no clips to align, just 3M. Can always use masking tape to mask off points of the old emblem before removing.

Just received my emblem from Billet Badges! Super excited to see how it came out! The custom upper and lower grille and emblem I purchased from Royalty Core will be here Friday. Hoping to install on Christmas. Will be selling the factory Chrome Laramie grille if anyone is interested! Moving...

I am so thankful you brought this up as it lead to me looking at the instructions. Lol I attached a screenshot. Looks like I’ll be calling the shop tomorrow and asking for a driveshaft replacement and asking them to finish the job!!

A recent noise has came about and it was found that the front driveshaft is rubbing on a plastic guard for a cable. Trouble is, I don’t see how or why this has suddenly become a problem. I did just lift the truck 6 inches, however, I don’t see how this would have changed anything to put the...

Thank you for your response!

Alright, so after reading through all 67 pages and 3 days later… lol I first picked up the parts to do the hack, then came across the TSBs on here. Just spoke with my dealer, truck is at 41k miles and I do not have an extended warranty. Dealer says TSBs are not covered outside of warranty...

Much better than basic 6 inch strut lift. I expected a lil better, however, realistically they are 37s lol. Might have seen that with a softer 35. I am happy with it though! Really absorbs large bumps well, speed bumps are night and day.