Recent content by tpoony

@turkeybird56 is this the bolt to take off and leave for 2 to 4 hours and then reattach?

Good luck @jwnelson3 . Keep us posted!

No. It’s more likely the software is simply not catching up to the state changes of the shifter fast enough. All this is drive by wire nowadays.

@RSConsulting , yeah, I am hoping that folks are right that I just turned the shift knob too fast. Will be much more careful with this moving forward and hope it won't happen again.

@Trfnj74 This is exactly the combo I am thinking about. I already have the MX4 installed on my 5.7" w/o RAM box with BUG. I had already bought the Mopar divider but it will need a bunch of mods on the divider rail in order to make it work. Thinking to change direction and buy an extender...

I am looking to see what bed extender would fit with my MX4 cover. Did you end up successfully installing the extender? Any advise or insights post install?

@MG99 is there a easy visual way to tell if I have the angled UCA? I took a few picks in case that is possible just by visual inspection without getting under the truck.

Thanks for the confirmation @MG99 ! Based on this as well as the info from @Pyleketerson , I definitely have leveling with some kind of spacer, maybe even be exactly the 2" ready lift that was shown. Follow up question, I have heard folks the leveling kits on 5th Gen that the control arms...

@MG99 a preloaded spacer meaning you think this was factory leveled?

Hopefully this isn't too dark. Is this enough for you to be able to tell? Thanks all!!

I just bought this as a CPOV. I didn’t even think to check at the time, but it seems my truck is unusually tall with both front and back standing at 38.5” with no load on 275/55/R20. I am indifferent about the leveled look and about to start towing a 5000lb Travel Trailer. Front Back:

I have CPOV with the powertrain 7-year extended warranty but wanted to upgrade to MaxCare. Since my truck already has 48k miles, it's a bit non standard from most people. Quoted for 8/100 with $100 deductible. Zeigler started at $1695. I asked to use the PAYINFULL $365 coupon but they said...

Hi folks, has any purchased mopar extended warranty from https://www.chryslerwarrantydirect.com/ ? I got quotes from Zeigler but their quote is $150 more than chryslerwarrantydirect.com. Thanks in advance!

hey Rick, sorry didn't understand your post. were those instructions? I was fully stopped every time between shifts.

No, straight 5.7 Hemi.