Recent content by That_hemiguy

I need help! I recently installed these and am getting rear endnote noise over certain bumps kind of clanking I have redone the level 3 times and can’t figure it out !

You have to click the maxtrac reverse level springs how do you do that?

I did the install but now Hear rear emd noise over bumps can’t figure it out.

Is this true with just there reverse level springs as well??

So I just lowered the rear with the Maxtrac reverse level and I’m experiencing an issue with the rear end making a clunk/ timing noise over certain bumps not all. Really only a couple but I feel it shouldn’t make the noise at all. I have re done the reverse level 3 times to make sure it is done...

Just installed mine and having issues with the rear making a slight noise over certain bumps I can’t figure it out.

I just put mine in and I’m hearing clunks on certain bumps everything is done correct

Yes then after about a hour of driving it goes to between 14.4-14.7 and stays there.

I have a brand new battery already.

So I’m having an issue I think. So it has been colder here when I start the truck my battery voltage is between 14.8 14.9 when it hits 14.9 the needle on gauge cluster jumps up one notch then back down to 14.8. After driving about a hour it goes back to 14.6 - 14.7. My question is it normal for...

Dude did you find the fix mine is doing it ?

Does your needle on gauge cluster jump up one line and back down? Mine is reading 14.9 -14.8 and needle is jumping up and down been really cold here also does that affect it?

I’m having the same exact issues can you help?

Yes and ok. Was just wondering if that was something normal to have the needle move like that?