Recent content by suli

All done, added my finished install pics to the how-to thread as well, turned out really good. https://5thgenrams.com/community/threads/how-to-adding-oem-upfitter-aux-switches-on-2019-ram-1500-dt.63897/

ALL DONE! Just in case to make future me not work as hard, added a ground to each plug. You could have just used 3 2-pin plugs with each side a aux power lead, but have 6 separate made it a bit easier later. I also just pig-tailed six grounds together to the ground spot in back of the...

I've FINALLY gotten around to making the fuse/relay box combo. I'll be finishing it all up in a few days and I'll add some more pictures and details for the box and relays I used (also using Delphi Metripak 280 style connectors, as it just makes it all easier. Yes, it's taken me a year to get...

I've FINALLY gotten around to making the fuse/relay box combo. I'll be finishing it all up in a few days and I'll add some more pictures and details for the box and relays I used (also using Delphi Metripak 280 style connectors, as it just makes it all easier.

Just an FYI, @vincentw56 was right, I was told I needed a whole new handle. I just epoxied it back on for now.

Well crap, maybe I'll try to glue this on then for now.

I piece of my passenger door handle came off in a car wash and I had forgotten about it. Anyone know what this piece is (pn) or do I need to get a whole new handle? It looks like it was stuck on with just white/beige silicone caulk (I can get a pic of the handle later).

Zone 6" Lift (rear Fox, front strut spacer) Black Rhino Rapid in Matte Black (20x9.5, -18 offset) Cooper Discoverer Rugged Trek in 35x12.5 Had slight rub on front forward inner wells - heat gun took care of it; had to trim the splash guard in the front about an 1" from the inside out. Sorry...

If you are not making a pigtail and inserting into each plug, don't push them all in yet, just place them in and double check your pin locations (they are keyed to go in a certain direction: Next, use a small needed nose and push them in one by one fully by row. They will fully seat, and...

Here's some good images of my pigtail building Made my new wire harness from individual high-temp silicone 20ga wire, wrapped with Tesa tape (fabric electrical tape): Marked the cables of where to cut/ strip/ crimp: If your crimper bends these slightly like you see here, just a needle nose...

Found a vid, this may help:

Added the jscan working in the Programing post

Two updates: Found the software updates for the 8.4 UAV versions, go here for getting to version 40.1: Radio Updates jscan works as well, worked with the Jscan app vendor and confirmed it worked with JSCAN, I updated the details here: Config aux switches in programmer

Nice troubleshooting. Did you also try a BCM restart with a tool? You may also want to just remove the + battery terminal, press the brake to make sure the system is drained, and wait a bit and plug it back up to reset all the systems. I haven't heard anything about a bad BCM drawing power...

UAQ Update Files for uConnect 8.4 - As of 12/28, they are available from this other forum and link: Additional UAQ/UAS Update Files 28.3/30.24/34.2 UAV Update Files for uConnect 8.4 (4C NAV) - As of 12/27/2024, they are available in the Pacifica forums, first post, google drive link...