Recent content by smoedog

Got a bad clunk in the front end. Both intermediate shaft ends are toast and my axles are bouncing around pretty good. Anyone sell a complete kit with both shafts, seals ect ect. I see the individual parts on rock auto, but i would prefer a kit in case I mass something

Ok, so now that I have installed old PCM, shouldn't it all return to normal

You mean the used unlocked ECU?

Got a diablosport trinity tuner and unlocked ecu off facebook (i know). When I installed it and tried to start the truck it cranked and started and shut off after about 5 seconds. All kinds of warnings, radio asking for unlock code, ect ect. Tried to write a canned tune to it, but it kept...

I ended up going with the 2r's, seller on amazon had them the cheapest i found. Impressed so far, rides so much better than the stockers.

With the Eibach's, do the rear springs provide 1" of lift on Rebels or non-rebel models

So I am currently running a 2.5" spacer up front and 1.5" in back (not installed in the photo). Also running TRX 35s. But I got 160k so the shocks are worn out and running rough. I don't really off road, but if I do, it's all low speed. I am really looking for something centered around ride...

Im wondering with the BG6600, if they did a flush. I would bet they did. Could have loosened up some material and filled up your valve body with crap and hence the ****ty shifting. They should have used the Mopar fluid, or ZF fluid, not some generic "compatible" fluid that is supposedly...

Or just drill a hole on the oem pan since you replace it anyways...just be careful on how deep you go...

Cool Bruh...learn a lot working on planes for 20+ years, mainly digging in and getting **** done and not overthinking it. 6 of the 8 cylinders are free and clear of obstructions. the aft cylinders on the drivers side are tough but no where near as difficult as people make them out to be. Like...

Replaced the wheel bearing a shop replaced 2 months ago...the other one they replaced lasted 2 weeks.

They used Precision Wheel Bearings from the box store. I had to use the same bearing they used to get back on the road. We will see if it lasts...if not i'll get some oem. Only thing I can think is either a bad batch of bearings, or since they rebuilt the entire rear axle, they drained all...

21 1500 Rebel, 3.92 e-locker...A few months ago my pinion bearing started going out and making noise. Took it to a highly recommended off road shop to get the rear-end rebuilt. I told them since they were that deep in there to go ahead and replace the axle bearings and seals while they were at...

I started with the pedal commander and after the 4th time it failed while driving and losing all throttle control I threw it away and went with a banks. the PC pulls power off the 5v reference wire. if it pulls to much, voltage drops, ecu freaks out...dashboard lights up and you lose your...

They weren't difficult at all...Used a magnetic swivel socket...threw an old blanket over the motor and laid down on top and knocked them out in about 45 minutes.