Recent content by Slinder91

So I can only direct you to air delete.com for part numbers. Mine was for a 2019 ram 1500 limited. Yours could be different per year, I’m not sure. Head over to there and check them out Sent from my iPhone using Tapatalk

So you can purchase the alphaOBD programmer from air delete with your order and send it back once you are done and they will reimburse you. The programming is very easy. They provide a simple step by step guide. It’s been quite a few months now to remember if I pulled a fuse but I don’t think I...

Hello all, finished installing the air ride delete kit that I got from airdelete.com. I went with the eibach setup and was able to program the truck at the same time. Truck kept dropping and couldn’t find a leak anywhere, even with pulling the boots back on the shocks. Ride quality comparison...

Hello all, today started awesome, driving my truck to get a coffee and had the service air suspension message come up on my screen and stuck in aero mode and can’t change ride height. These are the faults pulled, my question is, does everyone at home just fill the system with air to check for...

You’ll know when the rear bearing is seated all the way on the shaft when you can get the snap ring on Sent from my iPhone using Tapatalk

So this is hilarious, it’s not a special bearing.. it is the 6003-2RSH bearing. After a closer look, what had happened was the inside sleeve that was supposed to stay with the housing was frozen onto the bearing. Once I had it off, it just had to be tapped back into the housing. I tried to still...

Does anyone have the correct size bearings for the MGU? 2019 ram 1500 5.7 I’ve tried the McMaster part number 6661k86 and I’ve also ordered the 6003-2rsh. Both are too small Sent from my iPhone using Tapatalk

6003-2rsh bearing alongside the OEM. Sent from my iPhone using Tapatalk

nice job, I’ve been eyeballing that master set from ICON too lol, but without 100% confirmation that the front bearing I have would work, couldn’t see a point in potentially ruining it. I’m honestly suprised Ram doesn’t provide rebuild kits or bearings that you could order directly from them to...

Also, the part numbers everyone is referring to for the rear bearing did not match mine, I have a 2019 5.7, it has a snap ring and the bearing someone posted as being # 6661K86 is incorrect as that bearing is much smaller than the one in the rear. Also, others have mentioned #6203-2RS as...

I just took mine apart and have both front and rear bearings, I don’t think it’ll be doable to take that pulley off without damaging something. You don’t even have enough room to grab the pulley on the backside of it