Recent content by Qzip

That’s a very interesting point you’re making. Never thought of that. If that’s the case then buying the clamps from the dealer before doing the job would be the best thing to do.

Went to HD & purchased 5" hose clamps. Will be purchasing OEM clamps soon though. If they sell them...

I cut the existing clamps off with a dremel with the cut off wheel attachment. (Angle grinder was too big didn’t wanna cut the actual boot) Remove the 15mm drive shaft bolts Use a pry bar to pop off the shaft Use a jack stand to support the end you just popped off while you pull the shaft...

I ended up just leaving it in there. maybe it is used to reduce vibration like the fellas above stated.

Was greasing up the shaft, until I saw this sponge like thing inside the drive shaft…..no way this is from factory is it ? If it is can some one please school me on the reason why theirs a sponge inside the drive shaft tube?

Mine hangs around 13.1-13.7. I’m in the southwest temps are well over 100

I’m having the same issues, even after replacing the 12v battery

19’ 1500 8.4 base 6 speaker with anc. Looking to just install a single sub & my amp has speaker level inputs. Already have everything including the anc bypass harness. 1. Is their a harness out there that allows me to to keep ANC & still give me the speaker inputs to connect to amp/loc? I...