Recent content by PHFT

I know this is pretty old now and I can see you got the rims in your profile pic, did you have any issues with them on the stock duratracs?

If you look at my post #259 on this thread you can see the shark fin still sits above the top of the cap (without the rack that I added)

when it says "Lifted Steel Spring" is that for the Rams with the Off Road Package / Rebels?

Getting ready for an afternoon bear hunt tomorrow.

I'm not sure on the exact height it adds but it just clears the antenna fin so a RTT would fit, I took these two pics a while back that shows the height compared to the antenna. I think you can buy extra cross bars so you could probably piece something together if you didn't want to get the full...

Found my clunk, it was the sway bar upper end link on the passenger side, it was so loose I could tighten it with my finger tried to post a video but I can't for some reason....does anyone on here know the torque specs for this? Thanks in advance.

I have the 5.7 bed and have the Prinsu Design Studio Universal Top Rack mounted on mine, they make them for the 6.4 bed as well. I did have to also buy their Leer mounting feet so make sure you check your specs as you may need them as well if you go with this rack...

Here ya go, also did some top ones to show its pretty much the same height as the fin.

So I ordered the RSI cross bars back on March 7th and they still haven't shown up, thankfully that gave me time to really think and do some searching and I found that the Prinsu Top Rack was a better fit for my needs. So I ordered the 47'' x 5' one and I think it fits nicely on the smart cap...

Added the Prinsu Top Rack to the bed cap today.

Made a drop down rack out of some aluminium for my table so it can sit up against the bed cap roof and out of the way and drop down and slide out when I need it.

Thanks, I've had the idea for a while but wanted to wait for warmer weather to make peeling it off easier and needed to wait till my girlfriend had time to make the decals.

Finally had some time to peel off the RSI logo's on the sides and back and replace it some something better.

Finally had some time to peel off the RSI logo's on the sides and back and replace it some something better.

So I didn't cut any holes in the decked those were just there for the different mounting points depending on the truck model I think, but I just ran it through that hole and up the side (you can see near the factory bed lights) and zip tied it to the 3rd brake light cable, then used some sticky...