Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Has anyone successfully done this? Upgrade from non nav to 12” with nav, enabled chmsl in Alfa and had the cargo cam button appear? Mine will not appear on the 12”...
Does anyone know if you upgrade from the non nav to a 12” if you should be able to get the cargo cam button to show up? Mine is not showing up...any help?
when you guys reinstalled the third brake light was this stuff tougher to push down to seat the light? How tight did you do the screws? Just til they stopped turning and felt like they bottomed out?
Ah ok yeah that’s what I’m trying to figure out. I do have that same grille here though. Maybe I’ll go ahead and order that part number. Does it just pull out of do you have to remove the whole grille?
What is everyone using for power and ground for the camera? Also where did you route the wires including the av wire into the cab and behind the dash to pin the connector with?
In Alfa obd to change settings is everyone still using the Pacifica vehicle selection or do you use the MY19 vehicle selection?
Also are you guys disconnecting the battery doing the swap?
Can anyone point me to where about in this massive thread I can find the process for 8.4 non nav to 12” upgrade from start to finish? I’ve been through a good bit of the thread but it’s so much I must be missing it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.