Recent content by nickwille99

I was able to fix it. Had something to do with the XY400 connector under the driver seat.

Was able to get everything working. Ended up being some connection issues with the xy400. Once I got that sorted everything worked. Thanks for the suggestions everyone.

I think something may be up with the left side. I have been through now 3 different modules with the same result. Oddly enough, I am also having a problem on the left side where just the running light on the tail light is not working. I plugged my left tail into the right side and it worked...

I have OEM Mirrors that I purchased off Ebay when I added the 360 Cameras to the truck. I am able to go through and power on the LED indicator in the mirrors via Alfa. I can connect to the BSM module in the right side but get an error when trying to connect to the left BSM module

Didn't fix the problem. When I read all faults in Alfa i am getting 3 of them. U0010 (Unable to find what this code is), U0232 (Lost Communication with side obstacle detection module -left), and U0213 (Lost Communication with Mirror Control Module)

New modules did not solve my issue. When I check fault codes I get an error that there is no signal from the driver(left) module. I'm not sure what is going on now. I have purchased multiple different module sets, most recent is part number 68263397AE, and the XY400 harness I got is from Jimmy...

If it helps. I am getting this error code. Not sure if it correlates to my issue.

I have not used a volt meter yet, I have to go get one. I don't think the issue is the light itself. It worked when I plugged it into the right side and the one from the right side had the same issue when plugged into the left side.

Did you find a fix for this? I am currently having the exact same issue.

I am having a similar issue except I don’t get any light on the mirror when I start the truck, just the unavailable message after a few seconds. When I try to change the settings on the screen I get a message that bsm is unavailable. I think my issue may be one of the sensors since I bought used...