Recent content by nanthonyrhd1200

I went with the matte black as well. But I did remove all of the chrome badges and replaced them with matte black on the doors, tailgate and grille. Only thing left to do now is get black wheels! Sent from my iPhone using Tapatalk

You don’t have to. I “soft” wired mine in temporarily to test connection without and it worked just fine. Sent from my iPhone using Tapatalk

Finally got mine done. Removed ANC module under drivers seat and used ACH4 harness to tap into the input for speakers there with a Rockford Fosgate DSR1. Ran wiring down door sills to back seats for amp, then back under driver seat for output to speakers. Both input and outputs are available...

Well this should be fun. Mine just popped on for the same thing at 1,499 miles. First Ram that I’ve owned and that’s a little concerning. Sent from my iPhone using Tapatalk

Yeah it’s a 5 channel amp I planned to send to the kickers I installed in doors and dash. Once I get this figured out and hooked up I will then figure out the sub box/location and run to it as well. Appreciate the insight. I was assuming that was the case and It didn’t require the DSP, just...

So is the DSP required for aftermarket amplifiers on this truck? Or just a matter of preference and sound eq tuning..... I bought the 36 sq ft of Noico 80 mil from Amazon based on pricing and reviews. Stuff is super easy to work with it just takes FOREVER to apply correctly in all the doors and...

So the ACH4 harness will work at the white connector plugging into the module under the driver seat? I’ve already disconnected the 4+ wires for ANC since it went wild after installing both front & rear door & dash speakers. I’m guessing it’s due to the polarity being swapped after using the...