Recent content by N7GZN

https://5thgenrams.com/community/threads/adding-passive-entry-how-to.22274/

The CDT-69s can be ordered with either 2 ohm or 4 ohm impedance.

Many have upgraded the 6x9 mid-bass in the doors with CDT CL-69S's which greatly improves the mid-bass. The CL-69s just fit with no modifications. The H/K systems are around 4 ohm impedance, I do not know what the Alpine system 6x9 speaker impedance is however.

Check out this link, instructions on how to repair dash delamination by injecting glue underneath the leather. Thread starts at post #150 https://5thgenrams.com/community/threads/leather-dash-lifting-away-and-crating-bubbles-seats-peeling.23900/page-8#post-904226

It might be beneficial to remove the throttle body and clean behind the butterfly. Carbon build up here can result in erratic idle as it can disrupt idle air flow knocking the air metering off kilter. Simply spraying seafoam in the throttle body only may not remove all of the deposits behind the...

The link above has a method to utilize a strynge and inject a small amount of adhesive through the leather to reattach the leather to the dash. Everything can be procured from Amazon. This problem is compounded by heat, and leather cleaners which break down the adhesive. This issue is found with...

https://5thgenrams.com/community/posts/904226/

I finally finished the radio and touchscreen mount that installs inside the console. The radio is a Connect Systems CS800D dual band VHF/UHF analog and DMR FM radio, 50w, with a BFD touchscreen. Radio mounts underneath the console sliding tray, and the touchscreen covering up the phone slot and...

I've not seen any pre-made kits to integrate radios into the stock console of a 5th Gen Ram. I have a '19 Laramie Longhorn, and I dislike the sliding tray as it takes up a large portion of usable space that could be utilized for locking storage, and radio gear. By removing the sliding tray...

I just installed a dual band radio in the console, I routed the antenna cable and 12v power through the pocket. To get a clear path to drill a hole through the top wall of the pocket you have to do the following: Remove the front dash trims at either side of the console, they pull off and are...

All of the OEM mirrors have plastic gears, for weight savings which easily break. Look up Gruvenparts, they make brass replacement gears for all of the OEM's including Ram. Look them up on YT, the gear installation is not for the faint of heart, the gearbox has to be cut in half and then glued...

It was sold locally some time ago.

Duracell Platinum AGM, G94, 800 CCA, 80ah @C/20. I think the issue was not resetting the IBS system when it was replaced, the vehicle overcharged the new battery.

This is good to know, I just had to replace a H7 AGM that was replaced using the keep alive booster pack. It failed in less than 2 years of service, and exhibited evidence of overcharging. Last week I installed a H8 battery with a keep alive pack and have been watching the voltmeter closely, it...

The battery booster needs to be configured to act as a surrogate battery, as the original is completely flat. My NOCO booster requires a sequence of button pressing to place it in battery mode in order to keep everything powered after starting.