Recent content by mdw3998

Thanks for your input. Yes when the ECO light is off all 8 are running. Tow Mode does not disable MDS, on the Gear Limiter you have to hit - then + up to 8 (for an 8 spd tranny) then MDS is disabled. Per my previous update, with MDS off - no noise, with MDS on - noise. I replicated this back...

2019 RAM 1500 5.7 Big Horn 62k I get a weird noise when coming to a slow roll or a stop. It only happens when I'm in ECO mode Slowing down from 6th gear - about 35 MPH - coming to a "coasting" stop The noise happens around 10 MPH At 10 MPH: the ECO light goes off which I assume is about the...

SOLVED. After verifying tranny and rear end specs are correct they downloaded build software.

So after months of dealing with this vibration issue the dealer finally got a vibration analysis tool and tested my truck. He told me that no issue was found. I was furious at this point. I took the truck up on the highway and sure enough it was gone. I went back to the dealer and spoke with the...

I wish you well. This is really frustrating. Are you using a lawyer?

I've considered the same, however I can't find a decent brand for our model year yet.

I replaced the original 275/55 R20 Nexans with 285/75 R20 KO2s. Oddly that's when There is a flash update for the loud hum/droning noise from the noise cancellation system.

Yes, thanks - tried that. I believe Jason was referring to noise cancellation, not ATMMs.

I've read that it goes through the amp under the passenger seat, but I have not confirmed.

So if you unplug the amp that provides ANC it goes away?

If you just get a regular balance those dots should be lined up with the stems ( if they take the time to do it on a balance - should have been done when new). This way you can tell if the tire is slipping on the wheel, which is unusual unless they lather it up too much when mounting. However...

I was driving by one of those police trailers that tell you your speed. I looked down at my speedometer and it was 5MPH faster. I downloaded 3 speed apps and they all verify my speedometer is wrong. Besides annoying, it's adding mileage to the truck Anyone else?

Thanks. They already changed out the body mount bolts per the TSB. We'll see....

Will do. Today the dealer tech had a good idea. He took out the driveshaft and we went for a ride in 4wd. Didn't fix it, but eliminated it from the list. Perhaps others have a drive shaft issue and can try this as well. I wish I could find a place in New England that does on car tire balancing.