Recent content by MattB07

I just finished a test of 295/70/18 vs. 35X12.5 I have a 2" Ready Lift Level Kit. Tried both sets of tires on TRX take off wheels (18X9 +19) I felt the 295's looked too similar to stock. So crazy what a tiny difference in size makes. The 295s placed next to the 35s off the rack look so...

Finally completed my wheel/tire/spacer upgrade 2" Ready Lift front-level w upper control arm replacement TRX wheels (18X9 +19) 35X12.5 BFG KO2 1.5" Hub Centric Spacers (77.8MM bore...... critically important, do not get fooled for 88.1MM!!!) I was between the 35" tires and 295/70/18 and...

I think I'm experiencing the same issue HSKR R/T did. I bought 1.5" spacers off Amazon which "fit my vehicle" - according to Amazon with the spacer's stated bore of 78.1. I installed the spacers on my Rebel with the OE wheel/tire package. The spacers sat flush against the bearing assembly but...

Looks nice! Your factory ride looks taller than my 2020 Rebel! What's your measurement from hub center to fender lip, both front and back?

Looks great. What size tires are these? Thanks in advance.

What size tires are those?

Hank, what's your current height to top of shark fin? Thanks!

That's right around where I am, too. Each of my 4 corners is slightly different, but all are roughly between 40" and 40.5", taking into consideration my 2" level. Also, I'm at 80" to top of shark-fin. Compare that to the stated height for all trims on a 31" tire of 77.6". Add plus 1" given...

Good call about him possibly having the ORP. I hadn't considered that.

Also, I'm guessing my distance was 21.75" before my level kit. I'm at 23.75" driver side and a hair shy of 24" passenger side with my 2" level. So I could have been closer to your measurement pre-lift. Wish I had measured it prior to installation.

Found previous quote from another thread. Notice Tac747 does not have a Rebel but has roughly same distance. Good question about the fender flare. Who knows?!

You read the same info from Readylift that I did which triggered some of my confusion. They are convinced Rebel's do not have 1" lift. This is what triggered my curiousity and confusion. My mother in law has a Ram Limited. Last time she was in town I measured her rear fender height from...

I realize that is what is written. But this is not what is reality according to the tape measure.

Great info, thank you. Care to share a pic? Any lift or level?

Thanks AlaskaGT. From the Readylift chatter in Q&A, it sounds like some Rebels have the lift and some don't. By any chance are you able to measure the distance between the center of your hub and the lip of the fender, both front and rear? I'm at 24" at the rear. If yours is closer to 25"...