Recent content by lsupcar

Ok. I guess I should have done this first, but I looked up the part number on the tag and it is listed as the transmission case vent. Thanks anyway. Now if anyone knows why my front suspension is clunking I will take help in that direction as well. Haha

I was investigating a front driver side suspension clunk on turning while changing direction from forward to reverse. Such as when pulling out of a parking space or the garage. I did not find the cause of the clunk, but saw this hose hanging down from the rear of the engine region. The end...

Ok. Thanks for the education on the named Hybrid category. I did not see that category on Tire Rack. In regard to the duratracs, I do like the outlined white letters. Haha. Do any other comparable tires come with owl? But with better wet road traction. Thanks

I'm not sure what a hybrid tire is. Can you offer some examples? Thanks.

I'm following this. My Rebel Duratracs are getting worn I and hope to find a new set that continues to offer great mud traction but better wet road traction. Are K03"s good in the mud? Is the non OEM spec Duratracs different than the type that originally come on the truck? A Tire Rack...

My 2023 rebel is now in the shop the third time for a dtc po339 (crank shaft postion sensor a circuit intermittent). Started at about 24000 miles. now at 25500 miles. First time replaced the crank angle sensor. Few weeks later repeat code and limp mode. This time they replaced the PCM...

Point of reference. I weighed the RCI and factory skid plates. RCI front skid plates and hardware 1/4" ALUM powder coated: 27.6 # RCI Tranny and Tcase skid plates and hardware 1/4" Alum powder coated: 44.6# Total RCI Skid plate package with hardware 1/4" alum powder coated: 72.2# Ram factory...

I built a dead petal for my 2023 truck , but wish I had a factory item. I will have to take a look at the 2025.

RCI Metalworks Skid Plates: Engine, Tranny (and cat shield), T-Case Overview, Install, and Review Check out this thread going on now in the Modifications subforum. And yes, if you only install the front engine skid plates of the RCI kit, you can leave the factory transfer case skid plate in...

This is the kit I have. It has metric and sae. And pass through extensions. I don't use it often, but sometimes it is just the thing you need. In this application it was much easier to keep ahold of the nut with this than a geared boxend wrench. Both the stock front diff and rear transfer...

Here we go.. Bolted everything on tight. Instructions don't include torque specs.

Installed the skid plates this weekend.. Some before and after pics. The pass through socket wrench was helpful to tighten the bolts inside the front frame member. Instructions were not the best in regards to the clips but got it figured out. Will see how it goes when I need to change the...

Thank you.

Thank you both. Looking forward to hearing your report after your trip to Arizona. Safe travels.

Thank you. No overheating or cooling issues?