Recent content by Jstadick

I don't remember the brand type, but it's a pretty slim line case. The wife's is a little beefier and still does ok,

Same. Not sure what he's talking about.

There were no specs on the install sheet so I'm not sure of actual spec/limit. However, I can say that it is extremely well made with some pretty hefty bolt attaching it to the frame of the truck. There were no specs on the install sheet so I'm not sure of actual spec/limit. However, I can...

I guestimated and I didn't use LT but don't think a little dab of ol' blue would hurt.

I love it. The signature part of the interior. Not withstanding a few minor software problems here and there (as with all software and they release over the air updates to resolve), the functionality is awesome. The on screen climate controls work great but you still have the physical buttons...

Can anyone who has the update completed post the new version numbers?

While they can have limited help with laser, and zero help with VASCAR, they still provide a pretty good defense against traditional radar. I use my V1, Waze as @Royal27 mentioned, and good 'ol common sense with pretty good luck. But by no means is it foolproof.

Welcome! I must say, you have impeccable taste....:cool:

Not Not just a rubber mat, but this is what I installed in my Limited. Had it for a few weeks now and works great so far. https://5thgenrams.com/community/threads/bedtred-impact-bed-mat-installed.2875/

Welcome! I'm an old F150 convert. The Ram is an awesome truck and you'll find lots of extremely helpful info and folks here. Your only decision should be which model and which options!

Here you go.

Well, they confirmed it to be a fan noise, but after replacing the radio unit, the noise was still there. After 3 trips to the dealership, Turns out the cabin temperature sensor was loose. All they had to do was reattach it and all was good. (A lot cheaper than what they spent to replace the...

Are you talking about the bed step? If yes, here is a thread discussing. https://5thgenrams.com/community/threads/bed-step-install-doc-and-pics.2499/ If no, then sorry must be something else I'm unfamiliar with.

Yep. Super easy. Just tilt it up about 45 degrees And pull it off.

And this may help too. https://5thgenrams.com/community/threads/bed-step-install-doc-and-pics.2499/