Recent content by JJWerline

Nope! still the OG windshield with no tint on it. I just got word back from the Dealership that they replaced the BCM and its still doing it. Lord knows what is even going on at this point.

Has anyone experienced a bad BCM module yet? I have had TWO go bad on me in less than six months. I got the truck brand new in 2018- Its a 2019 1500 Bighorn. About 6 months ago I went to unlock my truck and the tailgate dropped. I thought....Well thats new! Seeing as i dont have that feature on...

The only way to keep the black clean is to paint the truck....anything but black LOL

Thats the adapters for the conversion you still have to buy the housing which is like $1500

did you truck come with this storage or is that something you bought?

Also after looking at the 56584 it’s a 5 pin connector. The connector on the light bar is 4pin hows the white wire get tied in? Is there something I need to put on it to plug it in or something (I’m new to this as you can tell) Sent from my iPhone using Tapatalk

i Stand corrected. i just checked and i have the Curt 55384 not the 56584... DAMNIT!!! lol

Thats the Curt i have. maybe i should check the reverse lights again. But the first time i checked it wasnt working. There is no where for the white wire from the OPT7 Bar to go to that Curt Connector. Or does it just work with the 4pin connector and you dont need to connect the white wire?

i have the Curt and it doesnt do the reverse lights you still have to spice into the factory wiring. the Putco ones looks like you no longer need to do that but i dont know if it works with the OPT7 Light bar or only with the Putco light bar

Do you know if that Putco Harness would work with the OPT7 Light bar for reverse lights?

Is that model number for Crew Cab?

Can i ask where you got the bed liner from and how much it was?

Whelp I just went and bought the light bar and spacers and saw for myself how it all went together. It was fairly simple. Sent from my iPhone using Tapatalk

With all the spacers and clips will the light bar be sticking out almost flush with the top of the bumper? or does it still sit back behind the bumper? I went through this whole thread but still have some confusion on exactly how everyone is mounting it. are you putting the clips on the spacers...

Hey Zig! im curious about the light bar you installed. How did you mount it so that its straight and goes out far enough to go past the back up camera wiring? those square pads aren't really that thick to make it past the wiring. do you screw in plastic spacers to the plastic then use the pads...