Recent content by J_Bone

Oh no.😟 I don’t have to worry about that in Arizona. 😎

I installed the Tazer to adjust the speed and fold in mirrors when I shut off the engine. It works great and leaves the OBD port open for other diagnostic or other controllers. After adjusting the speed for my 35’s, my gas mileage and shift points were where they should be.

I was under the impression it was a kit part.

Because they are the manufacturer and know the specific cable and length. Who would be better to ask to replace?

That’s a bummer. I would immediately reach out to Oracle and ask if they can send a replacement cable.

Click on their profile and you should see a button to ignore. I’m new here and I’ve already ignored people. 🤦🏼

Thanks !

It does every time!

Thanks man. I’ve thought about dechroming it, but it’s a lot with the grill and all the trim. I have ordered some bronze badging so it will have the chrome/bronze accents.

Hello, I inherited a 2022 RAM 1500 etorque Laramie from my father. I bought it with my father so he could have a bigger truck to get in and out while he was getting Chemotherapy. Fast forward to February and he passed. So I get his truck that he barely drove but crashed into a few things..🤣 Once...

Why would you say that it’s not good for off-road? I’ve used Bulletpoint mounts on my Jeep Wrangler and Gladiator with no issues what so ever. It even held my tablet without a hiccup.

Today I setup my Bulletpoint phone and GoPro mounts. The 3rd ball will get the radio mount. I know there’s a wireless charger below but I like it more visible when using an app.

No biggie, I appreciate the response. It has great information and I might switch the whole aux module because I want the switches more than I want the backup steering. I’ve towed trailers for almost 30 years and I don’t need the backup steering. It’s just a novelty gadget.

Thanks for the information. I still can’t find the switch I’m looking for. I want to keep the same layout and trailer controls, just want the added switch instead of a dummy switch. But if it’s not possible to get it, I’ll have to make my own.

I’ve got a 2022 RAM Laramie and I’m wondering if it’s possible to add 2 more switches to the existing switch board? I’ve searched and I haven’t seen anything specific to this.