Recent content by hydrant328

I was suspect too. Filled out the form, got a confirmation that it was being evaluated. Then got the notice that the check was being processed and shipped.

yes. my tonneau rails sit inside the "bed rail' not on top.

The C clamps aren't the issue. Yes you can place the first back(toward rear) from the clamp. It's the profile and depth of the rail. The Access cover I got, the rail are cut out where the bracket is, and sit on top of the bracket for support.

I really like it. Makes loading bags of mulch, sod, etc a lot easier. And you do not need to remove the factory brackets to install a bed cover. I got the Access soft roll and it comes modified to fit without removing the brackets.

Access Original Roll-Up Tonneau Cover - Roll-Up Tonneau Cover. Got it at auto anything. It's modified at the factory to fit the MFT angle brackets at the front of the bed. Easy installation. Just make sure the gasket is trimmed to match the rail modification. I tore mine and they sent me...

you didn't replace with anything?

how hard was the wiring and installation?

Im in south fla. I had a price done on a truck in Georgia. It was "damaged" they said in transit and they didn't accept delivery. I found another on the west coast of the state. Negotiated everything by email. Rented car one-way, drove 2.5hrs and picked up truck.. With rebates, credits...

im in ft lauderdale and bought from dayton andrews in st pete. 2301 34St North. I almost went to their clearwater location when picking up, so be sure which.

Under the backseat or in the floor storage boxes

Just noticed on my 4 month old 2020 bighorn 1500, that there are lights in the driver and front passenger footwell. If you dim the dash lights they dim, and if you brighten out the dash all the way they go out. Anyone else just notice these?

Yes, they said the braces are needed for the torque of the swinging doors. I got the access soft roll up. They modify the rails before shipping to you.

what engine and axle? I've got the hemi and 3.92 and got 21 on the highway doing 75.

I wonder if the install is different without the rambox. I only have the MFT. Does it pivot up and back into the bed?

Do you have the MFT? Any mods needed to install?