Recent content by Giattjos

I have a 2022 2500 Tradesman. I recently went from the 5” to the 8.4” radio i bought used. I installed it and now my backup camera gridlines are gone and the setting check mark disappears after a few seconds. I have alpha and am new to this. I enabled the gridlines using alpha but no change. Can...

Any solution?

I have a 2022 2500 Tradesman i upgraded radio to an 8.4 i want the gridlines turned on. Can someone tell me the steps from start to finish? I have alpha. I feel like my 5” had the gridlines but now i cant remember but feel like my 2022 should have them.

Thanks the sensors and tires are only two years old. The wheels actually sat in a garage for a year before i put them on. Would that seem strange for all 4 to be dead?

I have a 2022 RAM 2500 6.4 Tradesman. I upgraded the rins and tires off another ram to the black 20” and the tpms took a week to register. Then last week i put a new battery in and now rhe tpms is unavailable and all tires read 0. Ive driven a few hundred miles and no change. I went to a tire...

TPMS started working after a few starts. Guess they needed more time to acclimate.

For me i found out my garage opener only has enough memory for 7 programmable openers. I had forgotten i had too many, previous cars, so i to clear the memory and start over. Reprogrammed my current cars and openers and all my issues were solved.

I have the 5” and bought a 8.4 bezel that was supposed to be for my same exact truck but it doesnt line up. Very frustrating but does anyone know much about these? Should they be the same? These side holes dont line up and the radio bezel wont fit into my dash. Also my radio has the blue plug...

So im just seeing this thread and curious if the final verdict to move other cars you dont want to reprogram far away to program a new homelink? My RAM works then my VW doesnt, then i set the VW and my RAM doesnt.

I have a 2022 2500 and swapped the stock 18” rims for the RAM 20” black rims taken off another 2500. My tpms shows all 0 for all 4 tires. I drove for 25 miles no change. Im pretty sure rhey have the sensors but havent actually checked. Do these need to be reprogrammed? Or is there a reset that...

What gauge wire did you use? Did it work with no issues?

Anyone know where you can get just the harness for the visors?