Recent content by GadgetMason

No lift, max fit. Small amt of rub in one reverse direction at full lock. I have factory air ride.

Added some Molle to the back of the drivers seat

So far, enjoying the look/ride/sound of the 305 45r22 Nitto Ridge Grapplers.

I dropped in the Borla S-Type Cat back. Love it! Downside was I put in a Ranch Hand sport rear bumper which covered it… ended up paying a local shop to extend and center my Borla’s so I could see it again 😎🇺🇸 photos: 1. Stock 2. Borla added 3. Ranch Hand added 4-7. Exhaust extension and center

Just went over 14,000… took delivery June 23,2021 with 23 miles… feel your pain🤣 I took a two week trip out to Sturgis / Wyoming / Nebraska area. 5,700 miles! Ha! Break-in run.

It’s worth the wait!

Someone’s always gotta have a critical comment when someone has a nice thing to say.

It does remove some hold structure from the wheelwell liner, but I found punching a couple holes and adding a zip tie or two through the plastic takes care of that.

Now clean the rest of the stuff out of the left side. Here is a pic complete…

Love the look…

Be sure to put it in Jack mode before lifting in the center console. Otherwise the AFIT sus will try and compensate to keep the wheels on the ground.

Just went over mine with blaster also. Ramps too!

Thank you!

It’s a sickness I tell you! Latest adds: bora 1.25 spacers, Nitto Ridge Grapplers, Ranch Hand Sport rear bumper, Ranch Hand Midnight front Bumper/grille, 2ea Rigid Industries Radiance light bars, pair of under hood no-drill brackets and trigger 4 2.5Ghz wireless controller that @Waterfowler41...

Completed the front today… tired!